How to add an IP camera to a Hikvision NVR (Hikvision NVR Setup)
Вставка
- Опубліковано 4 гру 2022
- In this video, I explain how to setup a Hikvision NVR for the first time and add a new Hikvision camera to the PoE port. The NVR model is DS-7604-E1/4P
Hikvision NVR (Amazon Affiliate)
amzn.to/3Hss5N1
Hikvision camera (Amazon Affiliate)
amzn.to/3B9t80g
#bestsecuritydevices - Наука та технологія
I see it looks simple with the NVR with on board Poe... How do I add cameras when l connect to external Poe?
Remember some NVR comes with built in poe
Very good for beginners i have no router yet
Can you put any ip address for the poe ports?
Bro Can I contact you somewhere. i have the same camera… i use the netgear external router too view cameras on my phone.. need to set up
How do configue if i install 5 cameras to a external switch gigabit 8 port to a lan port if the nvr already have a internal switch 8 port? I junt one one cable to my inside hone insted of 5
One cable from the NVR Lan port to the switch.
I see you have the camera connected to the NVR.
Are you able to receive notifications to your phone for person detection?
yes
How do i know my ip for the nvr cause i tried the 245 one but it is not working still
have you figured it out?
How do I connect the Hik Connect camera cctv to a different network NVR..( via internet)
Hik-connect already works over the Internet, no matter where the NVR is located.
@@bestsecuritydevices I understand hik connect works over internet..but how add the address hik connect camera to nvr different place..please show the example.. thx
Hi why don't you enter the password camera?the dhcp is it anable in camera? Two please answer ❤️
Yes, the DHCP is enabled in the camera and the password is given by the NVR (it uses the same password for the camera).
My one says unable to reach camera address
how can i configure replacement of new ip camera to hikvision nvr
Just connect the camera directly to the NVR e it should automatically give it an IP and allow you to add it to the system
Hi i have hickvision nvr ds 7600 series and a reolink dome RLC 520 camera, in the nvr hikvision i went to event selected the canera enable motion, selected all area click apply, it says error settings. What it can be? I dont understand 😕 motion cant enable it just continuos
ua-cam.com/video/GHLYhTTEA9g/v-deo.html
how to add more than 8 camera in NVR hikvision?
You don’t
I had one ip camera is not working I just replaced a new iP camera and how do I setup and reprogram it’s thanks
i have a nvr HikVision DS-7608NI-Q2/8P with a reolink rc 810a 4k camera.
my camara record continuos ok.
in nvr settings i cant activate event motion, when i click enable and then apply a error failed settings appeared
ua-cam.com/users/shortsERK1l9dr69A?feature=share
Hi mate i moved to new shop and come with ip camera with password is it possible for me to unlocked please thanks
Need to reset it. The process vary depending on the camera model. Look for the camera manual online or how to reset the specific model you have.
Totally confusing
Dude, no need to talk with your hands. Its distracting and annoying.
You are the only one complaining and the video is not done exclusively to you, so just don’t watch it… there are tons of other videos out there ;)