Hello Sir in dynamic explicit analysis i have faced a issue that has been shown in monitor that total energy is negetive (cylinder under pressure) . I also checked too many times but it showed negetive. Is it my setup problem or is it ok?
Hi, In dynamic explicit analysis, if I use displacement BC and want my part to stretch 2mm, how should I tabulate the changes it in amplitude?. Thanks in advance
This is a very simple problem. The core of this problem depends on what the amplitude curve you want. If you want to simulate the quasi-static displacement, you may need use the smooth curve. If not necessary, you use the tabulate to define the initial moment and the terminal moment with a ramp type.
Thank you very much for your work ! It is very educational and nice to follow. Please keep updating ^^ (Maybe more cohesive zone modeling :D)
Nice😊
Hello Sir in dynamic explicit analysis i have faced a issue that has been shown in monitor that total energy is negetive (cylinder under pressure) . I also checked too many times but it showed negetive. Is it my setup problem or is it ok?
how to apply The constant friction shear factor or friction factor (m) in Abaqus Explicit instead of the friction coefficient
Hi, In dynamic explicit analysis, if I use displacement BC and want my part to stretch 2mm, how should I tabulate the changes it in amplitude?.
Thanks in advance
This is a very simple problem. The core of this problem depends on what the amplitude curve you want. If you want to simulate the quasi-static displacement, you may need use the smooth curve. If not necessary, you use the tabulate to define the initial moment and the terminal moment with a ramp type.