Making a DIY screen washout booth

Поділитися
Вставка
  • Опубліковано 30 січ 2025

КОМЕНТАРІ • 9

  • @christinalopez5501
    @christinalopez5501 20 днів тому

    Thank you for this video!!! I live somewhere where I can't just dump the water out. I use water based too. Never thought of flushing it down the toilet

    • @richardmartinez5040
      @richardmartinez5040 6 днів тому +1

      You can drain it out via a hose connecting to a bucket (for the disposable water) and mesh to filter out the emulsion from going into the bucket of water. There’s a few people that have tried it with success on r/screenprinting if youre looking for advice. Flushing emulsion of any kind is pretty toxic, its much better to separate it from the water and throw it out dry

    • @christinalopez5501
      @christinalopez5501 6 днів тому

      @richardmartinez5040 thank you so much!!

  • @christinakang203
    @christinakang203 10 місяців тому +1

    nick youve saved my life once again with the portable power washer rec!!!!

  • @noshankyouvm
    @noshankyouvm 10 місяців тому

    My BIGGEST issue is an exposure unit, are you still using the diy one? do you have a video on your current set up for that?

    • @someprintdude
      @someprintdude  10 місяців тому

      I'm not using the DIY one pictured, I didn't like it because it was hot and overexposed in the middle and underexposed around the edges. But I did make a new one using LED blacklight strips, and that one works great. It's basically a grid of LED strips all plugged into a power strip that I can turn on and off all at once. No video on that one yet since I built it before I started the channel.

  • @lonlida
    @lonlida 10 місяців тому +1

    Rüt beeeeeeeeeeer

  • @johntran8863
    @johntran8863 10 місяців тому +1

    First

  • @bonbanh3240
    @bonbanh3240 10 місяців тому +1

    First