Really it very useful for both students as well as faculty handling the subjects Sir . I had gone through all Lectures of R&AC and Heat power Systems for more than ten times Sir. And I suggested to all my students and colleagues to follow your priceless and incredible video Lectures Sir . Hats off to the Great Professor Rivi Kumar Sir.
Extremely well explain sir..thank u so much... I am expecting one lecture shell be made for winter heating load calculation with the same manner as u explain it for cooling load calculation..Your lectures very helpful ...
overall good lecture. but your shf line drawn is not parallel to the gradient obtained from circle on upper corner left. that is because you should never connect shf on rhs to room air condition. u should use only the gradient of the shf line on right hand side and use this gradient line to draw through the room air line.
Really it very useful for both students as well as faculty handling the subjects Sir .
I had gone through all Lectures of R&AC and Heat power Systems for more than ten times Sir.
And I suggested to all my students and colleagues to follow your priceless and incredible video Lectures Sir . Hats off to the Great Professor Rivi Kumar Sir.
Hi, Professor Ravi kumar. Thank you for this excellent series of videos you have uploaded, the quality of your lectures is outstanding.
Extremely well explain sir..thank u so much...
I am expecting one lecture shell be made for winter heating load calculation with the same manner as u explain it for cooling load calculation..Your lectures very helpful ...
a very good video understood problem very well good faculty
Thanks for class. It is crystal clear
overall good lecture. but your shf line drawn is not parallel to the gradient obtained from circle on upper corner left. that is because you should never connect shf on rhs to room air condition. u should use only the gradient of the shf line on right hand side and use this gradient line to draw through the room air line.
why can't we take specific volume at state 2?
everything became crystal clear in this lecture
How to select the ADP for following design condition.
1) Low temp & Low RH(68°F& 15%)
2) High temp & High RH (82°F&90%)
Kindly clarify sir
Depends upon the location and you can set it according to your desired conditions but they should be realistic 😉
22:40