Thanks for the video. In fact i couldn't see the part I was waiting for, that is the moment u reinstall the ps. In fact I've removed heads to correct warping, had a heart attack and there go 3 years I don't remember the position of brackets to link the pump again. Mine is 1995 2nd gen atm 3.0 3vze.
Cannot the the pulley off for the life of me. All other bolts and stuff came off fine but the pulley itself is stuck… and I can’t fully remove the long 14mm because it’s in the way.
You need to slowly hit the pulley with a hammer or a metal tool from the inside, hitting outwards (towards you), and it will slowly come off. Hope this helps
Thanks! I tried it for quite a while, but no luck. A neighbor said he has a puller I can borrow. If that doesn’t work, I’ll be forced to resort to dynamite.
I used a pry bar on my 94 3vze yesterday and it came off after hitting the pry bar a couple times with a hammer. i soaked it in penetrating oil and kind of rocked it back and forth off the shaft
Thanks for posting this, mine just went out. Same setup. Will definitely be replaying this 50 times on Saturday with a case of beer
Good video.
How did you remove the pulley
Thanks for the video. In fact i couldn't see the part I was waiting for, that is the moment u reinstall the ps. In fact I've removed heads to correct warping, had a heart attack and there go 3 years I don't remember the position of brackets to link the pump again. Mine is 1995 2nd gen atm 3.0 3vze.
Can you show me where the vacuum lines run. Mine were off when I purchased the truck and can't find where the line go
great video but would have liked to see how you drained all the fluid...
Did you use any tools to get the new pulley on? Or did you only use grease to help it slide on.
What fluid did u use
Where did you buy pump? And what fluid did you use?
Am a steering engineer by profession I work and repair all kinds of steering pump and racks for all kinds of cars
Cool I guess
how do you get the plastic out? holy cow😭
Cannot the the pulley off for the life of me. All other bolts and stuff came off fine but the pulley itself is stuck… and I can’t fully remove the long 14mm because it’s in the way.
Same here. Did you come up with a solution?
You need to slowly hit the pulley with a hammer or a metal tool from the inside, hitting outwards (towards you), and it will slowly come off.
Hope this helps
Thanks! I tried it for quite a while, but no luck. A neighbor said he has a puller I can borrow. If that doesn’t work, I’ll be forced to resort to dynamite.
I used a pry bar on my 94 3vze yesterday and it came off after hitting the pry bar a couple times with a hammer. i soaked it in penetrating oil and kind of rocked it back and forth off the shaft
*Promo sm*