I have a x30 175 i just had it rebuilt and its blowing oil out alot do you think the ballance shaft seal leaked ? Its way to much oil coming out the pipe
I need to change the piston, do I need to hone the cylinder too? When i measured the bore diameter, the different between average upper and lower end of the bore was 0.02mm.
Yes you have to measure the piston you are putting in and the bore with a bore dial gauge. Keep the clearance at 0.12 between the piston and the bore. Upper and the lower diameter difference is too high. Keep it less than 0.005
@@WheresmywingsRedBull First have a look and measure the cylinder and the new piston you are puting in, if the cylinder is in good nick and the clearance is good, just use a cheap flexible or ball hone to hone it up. If you have to bore it up further, you can use a flexible shaft hone or you can use more rigid hone. But rigid hones are bit expensive. We use both rigid and flexible hones for boring.
@@WheresmywingsRedBull Stick to the overhaul manual on that. If you want the overhaul manual just click on the link. iameusaeast.com/pages/technical#ka100
Great video 👍🏻
Which grease product do you use on oilseals ?
Which brand and model ?
Thanks a lot
@@odensepils Thank you ☺️
Any rubber grease can be used.
Great video , but please move the "music"
I have a x30 175 i just had it rebuilt and its blowing oil out alot do you think the ballance shaft seal leaked ? Its way to much oil coming out the pipe
why is your piston 56.336..? my actual is 54.110 on a 54.22V
I need to change the piston, do I need to hone the cylinder too? When i measured the bore diameter, the different between average upper and lower end of the bore was 0.02mm.
Yes you have to measure the piston you are putting in and the bore with a bore dial gauge. Keep the clearance at 0.12 between the piston and the bore.
Upper and the lower diameter difference is too high. Keep it less than 0.005
Thanks for the response!@@lifewithus7198
Hello! Is there a special recommendation for the Crankcase Seal lubricant?
Hello, use a good rubber grease.
What clearance do you recommend between piston and cylinder?
Keep the clearance between the piston and the bore 0.12 weather its a R or V piston
Great video
Thank you
What hone do you use?
We use a adjustable six stone hone for boring and honing, but you can use a flexible shaft type hone or a ball hone.
@@lifewithus7198 what hone do you recommend for a IAME KA100 for doing a top end rebuild?
@@WheresmywingsRedBull First have a look and measure the cylinder and the new piston you are puting in, if the cylinder is in good nick and the clearance is good, just use a cheap flexible or ball hone to hone it up.
If you have to bore it up further, you can use a flexible shaft hone or you can use more rigid hone.
But rigid hones are bit expensive.
We use both rigid and flexible hones for boring.
@@lifewithus7198 ok thanks, also what would be the ideal clearance?
@@WheresmywingsRedBull Stick to the overhaul manual on that. If you want the overhaul manual just click on the link.
iameusaeast.com/pages/technical#ka100
sorry but the music makes the video unwatchable