Pocket hole clamping jig to keep panels aligned
Вставка
- Опубліковано 27 бер 2024
- This creative jig project idea is perfect for beginning woodworkers. It will prevent the problem of keeping boards aligned when using pocket hole screws.
House Doctor Ray Amazon Shop
www.amazon.com/shop/housedoct...
Matchfit clamp kit amzn.to/3NJyo1w
Microjig Matchfit router bit and guide amzn.to/4cA60J9
Microjig Matchfit pro kit amzn.to/4cxdxbP
Kreg pocket hole jig amzn.to/4cCJ9Ns
pocket hole screws fine amzn.to/3TD7Gcd
pocket hole screws coarse amzn.to/3TUUFfH
Problem solver tee amzn.to/3OcHeF6
Premium problem solver tee amzn.to/44JpUNa
Blacksmith tee, women's amzn.to/3K0h2fd
Blacksmith tee, men's amzn.to/3JXqPlZ
To subscribe / @housedoctorray
Get your House Doctor merch here: my-store-11615387.creator-spr...
As an Amazon Associate I earn from qualifying purchases. Using the links provided does not in any way increase the cost to you, however any income I get from them helps support my channel...thanks.
HouseDoctorRay.com - Навчання та стиль
"Close enough for government work". A Farmer i worked for as a teen in the 80's would say this all the time. Still brings a smile to my face. Thank you.
Good Grief!!! Three minutes of content in a three minute video!
You're going to break the UA-cam maker verse, nice work and thanks.
Thanks Brian
That's cool!! Might have to try this. Peace
Once you get a set of Matchfit clamps you'll think of all kinds of things to do with them.
This is my favorite so far.
ua-cam.com/users/shortsL_3vZdrCrCs?si=QVVMe8LWiBUG0EEk
Cool idea. I usually a few dowels between the pocket screws. Don’t even have to glue them.
You’re going in the wrong way
You are correct!
You ideally want to have the screws going into the middle of the board, and not out towards the edge.
Not necessarily. The box I was building needs to look better on the outside.
Way over thinking it...
In 13 years of cabinet building, I've glued panels less than 5 times (except drawers)
Pocketholes should also be going towards the middle of the board, not out to the edges.
Better clamping, and anticipating the 'movement'.
On wider boards, do the first screw on one end, and then set clamps on each screw along the joint,
Unless the panel with the pocket holes is going to be seen.