Great vid and would respectfully like to add the following additional ideas/comments to this project: Lower main mast and rest forks on a pallet. Allows chains and pipes to slacken. After disconnecting chains and removing top pulley assemble, unscrew the retainer as shown and when free use forklift hydraulics to raise the mast cyl until it just pops out the cyl housing. Replace the seals as shown and reassemble onto the piston. Pump out the oil in the cyl using a small liquid pump (drill type works well) into a clean container and using the plastic seal guide over the top of the cyl threaded area, lower piston into the cyl easily. Remove plastic seal guide and reassemble as shown. Just did this today by myself (Billy No Mates!!) and everything worked well. Hope this helps.
Thank you VERY MUCH for this great video! I watched it a couple of times before repacking our Hyster 35XM mast which was very similar. Thanks again, I really appreciate it!
Thank you for this video, very helpful and saved me a bunch of time!
Great vid and would respectfully like to add the following additional ideas/comments to this project:
Lower main mast and rest forks on a pallet. Allows chains and pipes to slacken.
After disconnecting chains and removing top pulley assemble, unscrew the retainer as shown and when free use forklift hydraulics to raise the mast cyl until it just pops out the cyl housing. Replace the seals as shown and reassemble onto the piston.
Pump out the oil in the cyl using a small liquid pump (drill type works well) into a clean container and using the plastic seal guide over the top of the cyl threaded area, lower piston into the cyl easily. Remove plastic seal guide and reassemble as shown. Just did this today by myself (Billy No Mates!!) and everything worked well. Hope this helps.
Thanks for showing this it doesn’t look that complex so if I ever run across a forklift hydraulic problem this video get me covered
Thank you VERY MUCH for this great video! I watched it a couple of times before repacking our Hyster 35XM mast which was very similar.
Thanks again, I really appreciate it!
Thank you
Thank you for taking,filming, steps to rebuild most informing for us who do not know.
special place in heaven for people like you
Thanks bro you save my day big time 🎉
thanks for sharing
nice
Does this procedure work pretty much as shown, on a an older cat GC-15K that has main cylinder leak?
Why did you need to use the crane?