Check the pins too I just did mine and one of the pins were taken by the green , if you put a new door harness in clip a hole in the bottom of that boot to let water escape
Hi, my passenger side window switch only raise the window but window doesn’t go down. And the main driver switch for passenger window doesn’t do anything. My motor is fine I teated it but can tell what’s the issue the wires seems fine too. Now going to buy all the switches. Can you please tell how to put the rubbers back properly, mine are not snug now.
I have the very exact problem water and all, except my wires seem to be ok. Any thoughts on where I should look next? I took out the actual switch and looked at the wires, and those seem ok too. I even went as far as purchasing a new switch... nothing. I'm not sure what to do, but just keep the window up because, as you said, sometimes it's a few days later, and all of a sudden, it works fine. Then I shut off the van, and next time, nothing. I'm going to make a jumper wire and see if that works on the blue???
Hey bud, it's been awhile since I found my problem but check the wires good. My initial inspection one of the wires looked fine and after tugging and pulling on it to try and get the rubber boot far enough back to solder the new wire on the blue that's when the other wire broke. I would ohm test the wires while wiggling and tugging on them to be sure. Or like you said maybe a jumper wire to the motor switch to make sure all is well there.
Check the pins too I just did mine and one of the pins were taken by the green , if you put a new door harness in clip a hole in the bottom of that boot to let water escape
Hi, my passenger side window switch only raise the window but window doesn’t go down. And the main driver switch for passenger window doesn’t do anything. My motor is fine I teated it but can tell what’s the issue the wires seems fine too. Now going to buy all the switches. Can you please tell how to put the rubbers back properly, mine are not snug now.
I have the very exact problem water and all, except my wires seem to be ok. Any thoughts on where I should look next? I took out the actual switch and looked at the wires, and those seem ok too. I even went as far as purchasing a new switch... nothing. I'm not sure what to do, but just keep the window up because, as you said, sometimes it's a few days later, and all of a sudden, it works fine. Then I shut off the van, and next time, nothing. I'm going to make a jumper wire and see if that works on the blue???
Hey bud, it's been awhile since I found my problem but check the wires good. My initial inspection one of the wires looked fine and after tugging and pulling on it to try and get the rubber boot far enough back to solder the new wire on the blue that's when the other wire broke. I would ohm test the wires while wiggling and tugging on them to be sure. Or like you said maybe a jumper wire to the motor switch to make sure all is well there.
@@bereal74 will do! Thanks man!
The passenger side can help us. Sometimes the mirrors work and sometimes they don't, and the wires are good and the fuse is good.
Me too