Masonilan positioner calibration

Svi 2 model main turbine seal steem positioner

[@instrumentation12]

Positioner side revers action is possible or not possible

[@mdabusaba7780]

Thank you

[@syedmohammadanwer8358]

Bahut acha

[@hasanshaikh469]

Very nice

[@instrumentation12]

Revers action it is possible or not

[@Technicianbaba]

Reverse action is possible via dcs comand program

[@FarukHossain-dv9dt]

Bai hart and FF type Aki System

[@Technicianbaba]

Both present

[@instrumentation12]

There is no DCS available, or the PLC memory is full, so downloading is not possible. What actions can be taken with a positioner in this situation

[@Technicianbaba]

Change the ATO TO ATC

[@Technicianbaba]

It will reverse

[@Technicianbaba]

Where are installed positioner

[@Nehaprasai10]

T s need to be on for tight sut off

[@jonathanyema2765]

Good Day sir.
May I ask, after we calibrate and tune.
Why it was still giving 10% Open in our Kongsberg system (Monitoring system)?
Even though it was commanded to fully close from the Operation Station (Kongsberg)

[@Technicianbaba]

Sir check the output mili amp check settings full open. 20 ma and close 4 mili in setting parameters

[@Technicianbaba]

Adjust the link rod travel

[@Technicianbaba]

Insured your output milamp is going to DCS 4miliamp

[@hKumar-xx2qr]

Air leak ho tho kya kare

[@Technicianbaba]

Where's is leaking

[@mohammadsaddam9915]

Sir ou put me MA nhin mil raha hai kya kroun

[@Technicianbaba]

We will check

[@Technicianbaba]

Sir cable me voltage mil Rahi hai kya

[@marimuthumuthu9126]

Sir why TS off please reply

[@Technicianbaba]

When you tight on it stuck on open because it close force long time then it happens so it of or you may on tight close.