Це відео не доступне.
Перепрошуємо.

4 Signs of a Bad Blower Motor Resistor. How to Test & Replacement Cost

Поділитися
Вставка
  • Опубліковано 7 сер 2024
  • amzn.to/3qYbzhc - OEM Blower Motor Resistors
    amzn.to/3NebLCc - All-in-One OBDII Scanner
    You want your car to be at the right temperature when you drive. But sometimes, a part called the blower motor resistor can go bad and make your ride uncomfortable.
    This guide will help you understand what the blower motor resistor does and where it is. It will also tell you how to check if it is working and how much it might cost to fix it.
    Timecode:
    00:00:00 - Intro
    00:23:00 - Airflow Settings Not Working
    00:50:00 - Blower Motor Works On One Speed
    01:28:00 - Intermittent Fan Speed
    01:40:00 - No Air Coming From Vents
    02:14:00 - How to Fix?
    03:29:00 - Replacement Cost
    ******
    Disclosure: As an Amazon Associate, I earn from qualifying purchases. This means that I may receive a commission if you click on an Amazon Affiliate link and make a purchase. This helps support my channel and allows me to continue to make videos like this. Thank you for your support!

КОМЕНТАРІ • 33

  • @magnoliaalexander9606
    @magnoliaalexander9606 11 місяців тому

    Thank you so much for this information

  • @bretgtimk7968
    @bretgtimk7968 2 місяці тому

    i have a problem my blower motor is on speed 5 but after a while slows down to 3 by itself. Then after a min speeds back up to 5. would this be the resistor or blower?

  • @garynash1802
    @garynash1802 Рік тому +1

    So here is my issue. I have a. 2012 Ram 1500, ac was working as it should very cold I might say then I started smelling wires burning and the ac stopped blowing cold air. The heater works and all blower speeds work. Is it possible condensation found it’s way to a wire connection and cooked it? Just trying to get ideas before I start taking the dash out. Thank

    • @snowflameshots
      @snowflameshots 11 місяців тому +1

      If you are only blowing warm air, then you have a bad blend door motor . The blend door motor is what controls the climate of your vehicle.

  • @Piticbazat
    @Piticbazat 4 дні тому

    My blow motor is not working on Lincoln mkt 2014 which fuse I need to check

  • @adolg4049
    @adolg4049 6 місяців тому +2

    My ac 2 days ago was working very fine but then starts loose power air blowing and sometimes stops and starts itself but not fully power like once I own mk4 tdi golf

    • @imgrindin
      @imgrindin 5 місяців тому

      sounds like a clutch or compressor for the ac unit. lots of vids on youtube check them out!

  • @grudgeracinmedia
    @grudgeracinmedia 11 місяців тому +1

    What if ac just runs will not cut off until you turn the vehichle off

    • @ylee280
      @ylee280 2 місяці тому

      Could be bad pressure sensor or heater core temp sensor. One of those could be the culprit. You’ll need to do more research for your specific vehicle to see if it has those and if they fail often.

  • @anthonyporcarellosr3627
    @anthonyporcarellosr3627 10 місяців тому

    I have a question more than a comment, my A/C works only on hi so I purchased a new resistor, pulled out the old one put in the new one and I get nothing? It doesn't even come on an any speed?? any suggestions as to what the problem is?, I did notice that the connector did have a small burn on it and I have not replaced it yet, do you think that could be the problem as to why the new one doesn't work at all? Believe it or not I have replaced it with 2 different new resistors and gotten the same result....nothing.
    Any suggestions would be greatly appreciated.
    thanks

  • @charlesriley9426
    @charlesriley9426 День тому

    Cheaper prices on eBay for resistors

  • @1awsomeface
    @1awsomeface Місяць тому

    In my Nissan 2012

  • @marcopimentel1152
    @marcopimentel1152 11 місяців тому +4

    so in other words,i cant do it myself

  • @reptilesfishandmore
    @reptilesfishandmore 6 місяців тому

    My 02 muatang needs either a new blower motor in general or new resistor....ill probably replace both given age of the car.....smell of burning plastic only when the air is on is a fantasic smell 😂

    • @misc376
      @misc376 2 місяці тому

      You probably figured it out by now but burning smell is definitely the resistor.

  • @1awesomeface
    @1awesomeface Місяць тому

    I hit the glove box and it started working again but I have to do this every time it stops

  • @surfer103
    @surfer103 11 місяців тому +1

    Can the wiring for the resistor get hot? If so, what would be the resolve?

    • @charlesfields7908
      @charlesfields7908 10 місяців тому +1

      The blower motor is pulling more amps than what the resistor is rated for. Not enough to pop a fuse but enough to make the wiring get warm. Only thing that should get warm/hot to the touch is the resistor itself.

    • @surfer103
      @surfer103 10 місяців тому +2

      @@charlesfields7908 Thank you it makes a lot of sense. Have a Great day.

  • @1awsomeface
    @1awsomeface Місяць тому

    Versa

  • @markmcilrath9530
    @markmcilrath9530 9 місяців тому +6

    I bought a Dodge once...bought a new Fotd once too. Thats how I learned Only a Fool makes the same mistake twice😂

  • @llorylloyd
    @llorylloyd 26 днів тому +1

    I just got a $1200 quote

  • @1awsomeface
    @1awsomeface Місяць тому +1

    No air is coming out

  • @drumbyte
    @drumbyte 11 місяців тому +1

    My blower motor is held by 3 screws under the glove compartment. Instead of consult a professional, how about look at some UA-cam videos.