How to Separate the Turn and Brake signals

somehow TikTok helped me figure out how to separate the brake and turn signals out so that we can wire them up to a show mode module without issue!
2 to 3 wire converter: amzn.to/4d5P8uj
Ultrasonic cutter - amzn.to/46wgTZv
Dremel - amzn.to/2uDjjbO
Dremel Flex Tool - amzn.to/38mRpPV
Dremel Quick Release - amzn.to/2tUUcB2
Dremel Diamond Bit - amzn.to/2uFPmaZ
Plastic & metal adhiesive - amzn.to/37cIwXS
Wire Strippers - amzn.to/39thgWI
Soldering Iron - amzn.to/2SFCw4q
Solder - amzn.to/2HgX7qA
Heat Shrink - amzn.to/38qFyAA
Heat Gun - amzn.to/2UJjwVx
Zep - amzn.to/39pqTpd
RetroRubber - amzn.to/38fmsNz
Impact drill - amzn.to/3bASPbN
Goop adhesive - amzn.to/46kgXuf
Black silicone - amzn.to/3G1uvAd
Buy me a coffee -
www.buymeacoffee.com/ZacCook
Videos Shot on:
Canon Rebel T6 - amzn.to/2SGrCf7
Phone Tri-pod - amzn.to/2HceVTX
Amazon prime 30-day free trial link:
amzn.to/3bsdM8t
*These are all affiliate link, I do get a commission from each purchase made from the links*
#ntxglow

[@nascardrawings7700]

A lot of people will see this that just want amber turn signals instead of red. It is a safer option. You can wire this module up so you can put a switchback bulb in your reverse light section of your tail light. VLEDS did this with the Tacoma, and it’s called VTails. I did this in my Dodge sedan that had a stop and turn setup. Very easy and recommended mod.

[@zaccook]

Thats smart! a little safer and it helps you stand out

[@FittedLabs]

🎉🎉

[@xXIBON3ZIXx]

I tried this method but when i press the break it sends a .5s flash to the turn signal wire then turns it off and powers the break light. Might try your module mine was different

[@zaccook]

oh that sucks! To be honest im not 100 percent sure if this one had a delay or not as I couldn't see it when setting the brake lol

[@RazoE]

Definitely wanna try this on my Escape. From the factory there's a small provision for signals, but it's blanked off 🤔

[@nascardrawings7700]

What year escape?

[@RazoE]

@@nascardrawings7700 2012. 1st Gens have amber signals, but they use a relay system while the 2nd Gen uses BCMs

[@zaccook]

hmmmm maybe you drill it out and put in a bulb haha

[@nascardrawings7700]

@@RazoE depending on what your reverse bulb is you can put a switchback bulb in your reverse light

[@RazoE]

@@zaccook that's the plan!

[@hclan5876]

Grab a new relay I did that stopped the hyper flash