@@lmorrison17 Thank you for this response. I figure I was doing too much with my weed eater. I don’t know how to work on my battery so I will just buy another and go easy this time.
hey lmorrison17 is it possible to jump a completely dead 0.0 hyper tough 20v max battery. because i plug it into the charger only one green light is on... when normally charging a batter both indicator lights come on. thnks
Anything is possible, but I wouldn’t do it without taking it apart and verifying that each cell will take voltage individually without overheating or going short.
I just wanted to see what cells were in it. Not accomplished. I'll just take it apart and see for myself. I'd like to upgrade the cells in my old grinder battery. I should just buy a dewalt since I already have batteries to go with my dewalt tools. However I already own an old ht grinder and therfore can't justify buying dewalt grinder just yet. Especially considering I have old cars to keep on the road and bills to pay. Good job rigging your buddy's battery for him. God bless
Clean, flux and tin everything then it will take solder just fine. Also don't heat the solder. Heat the (prepped) work, then feed the solder into the work.
I have done maintenance myself and I seen results in the battery lines. Outside. Inside. And in stores. On cars and even light bulbs
Interesting, but if only there was a way to switch out a busted fuse for safety and convenience. Thanks for posting.
I suppose you could solder an axial fuse and tuck it in. But you’d have to find out what the value needs to be.
3amp max
Update? Did the tool keep working? Battery still good? Any idea why the fuse blew?
Good info. Thanks!
as far as i know the tool is still working. Cells of the battery were fine. It blew because too much load was put upon the tool.
@@lmorrison17 Thank you for this response. I figure I was doing too much with my weed eater. I don’t know how to work on my battery so I will just buy another and go easy this time.
Same drill, mine charges but only lasts about 5 minutes lol 🤦♂️
Probably has a bad cell or cell group.
hey lmorrison17 is it possible to jump a completely dead 0.0 hyper tough 20v max battery. because i plug it into
the charger only one green light is on... when normally charging a batter both indicator lights come on. thnks
Anything is possible, but I wouldn’t do it without taking it apart and verifying that each cell will take voltage individually without overheating or going short.
Good job pal
I just wanted to see what cells were in it.
Not accomplished. I'll just take it apart and see for myself.
I'd like to upgrade the cells in my old grinder battery.
I should just buy a dewalt since I already have batteries to go with my dewalt tools.
However I already own an old ht grinder and therfore can't justify buying dewalt grinder just yet. Especially considering I have old cars to keep on the road and bills to pay.
Good job rigging your buddy's battery for him.
God bless
Same problem but the Fuse IS good! Now what?
If it was me, I would take my multimeter and start looking for a broken connection.
I have same problem, fuse is OK , but drill does not work... only blinking light !!! Any solution?
Clean, flux and tin everything then it will take solder just fine.
Also don't heat the solder.
Heat the (prepped) work, then feed the solder into the work.
Have 3 of these batteries all doing same thing
Interesting... make sure your camera is pointed in the right direction dude !!
roflmao... don't bother filming !!
Wish your "fix" wasn't out of view..
Why did you waist my time
Waste
lol why did you watch?