How To Fix And Replace Needle Bar For Juki Lu-1510N-7.

How to fix and replace needle bar for juki Lu-1510N-7.
1) Height of the needle bar
1. Set the stitch dial to “0”.
2. Loosen two setscrews of the face plate to remove the face
plate .
3. Turn the handwheel to bring so that needle bar is raised from the lowest dead point of its stroke .
4. Loosen clamping screw of the needle bar holder.
At this time, loosen the screw to such an extent that needle bar moves up and down by hand since
needle bar drops if the screw is fully loosened.
5. Move needle bar to adjust so that the distance from the top end of the needle eyelet to blade point
of the hook ,Then tighten clamping screw of the needle bar holder.
6. Attach the face plate using two setscrews of the face plate.
(Standard) When the needle bar is in the lowest dead point of its stroke, the distance between the
lower end of needle bar rocking base and the lower end of needle bar .
See more related video subscribe technical access and press bell icon.

[@weightvest]

I have learned a lot from your videos, can you please show how to adjust the tail trim length so the thread does not come out of the needle? Thanks!!! Best ever tutorials for Juki LU1510.

[@SimonMwila-g5e]

What problem to cut cotton

[@kumarda5740]

Good sir

[@jhzgameplay5499]

good..