Couldn't remove the motor when hitting the gearbox housing as shown in the video. Some people were able to remove it by hands alone. Only when using block of wood against the motor flange and hitting with a hammer as shown in a jblat video I was able to remove it. Others had an broken axle failure after a while as a result of using a hammer. I might have hit the block of wood a bit too hard on the one side. Will see if the axle will brake or not. Shame there aren't any recommendations for motor puller in this video or in the original repail manual.
Hello i have a problem with the insatalation of my okfeet i have no assistens from my motor wen i plug in the trottle a rench apears on my display for the rest everyting looks normal this is my 4t bike instalation never had a issieu can you help my plz thanks
Thank you very much!
Thanks, what part do you grease if the motor is making a rough noise?
Thank you for informative video.
Couldn't remove the motor when hitting the gearbox housing as shown in the video. Some people were able to remove it by hands alone. Only when using block of wood against the motor flange and hitting with a hammer as shown in a jblat video I was able to remove it. Others had an broken axle failure after a while as a result of using a hammer. I might have hit the block of wood a bit too hard on the one side. Will see if the axle will brake or not. Shame there aren't any recommendations for motor puller in this video or in the original repail manual.
Thanks a lot ^.**
Informative video.
what part do the three springs play..? behind sensor plate.
Does this reduction gear fit in the Bafang bbshd?
Hello i have a problem with the insatalation of my okfeet i have no assistens from my motor wen i plug in the trottle a rench apears on my display for the rest everyting looks normal this is my 4t bike instalation never had a issieu can you help my plz thanks
Not a very good video, you could have done much better