How to use: The RockBoard MOD 1 All-in-One Patchbay by Warwick

Поділитися
Вставка
  • Опубліковано 4 гру 2024

КОМЕНТАРІ •

  • @michellelaverickmusic
    @michellelaverickmusic Місяць тому

    I notice you have the rockboard power supply on the board itself - but not underneath the board... any reason you did that...
    I've got a Flex2 from Grace Designs, and I was hoping to patch its XLR out to the out on the rock board - and then off to the desk. I noticed in the comment below that David said the slots were too small to get an XLR through? Is that correct... I'm guessing the only way around that is to make the hole bigger - or soldier off the xlr jack and solder it back once the cable is thru the hole?

  • @macoticoz77
    @macoticoz77 4 місяці тому +1

    Hi, I have a Rockboard Mod 2 v2, and when I go from the guitar directly to the Fender Buffer Level pedal, everything is fine, but when I want to enter through the patchbay and then to the buffer, it generates a small noise... with respect to the outputs everything is fine, there is no noise, I have an MXR10 band where at the end I divide the signal, one for Iridium and another for the amplifier, all of that through the patchbay, the noise is only when I go directly to the patchbay before the buffer... that's it bro, greetings!

    • @MusicMadnessM
      @MusicMadnessM  4 місяці тому +1

      @@macoticoz77 thanks for sharing that observation, can't say I have had the same issue though! But allways good to hear other peoples experiences!

  • @davidgriffith3938
    @davidgriffith3938 3 місяці тому

    What good is the XLR pass through on the module when an XLR cable will not fit through the slots to get to your pedal that has an XLR? And, BTW, installing that module is a frustrating pain in the ass because of the tiny screws and nuts with the weird star slots instead of standard philips slots. I was SO disappointed with my Rockboard, it sits on a shelf unused.