This has been a very helpful video, thanks! Excuse my ignorance, but are these flanges only on the front axels? Also, would you include the part numbers for the flanges and the gaskets? Thanks!
Great video, and I can't help to noticed you have a diffrent set of rims on your 100 series Landcrusier. How did you get them to fit. I also have the same rims but I can't get the center hub cap to fit flush.?
This was a super helpful video in giving me clues on what could be causing my LX470 to have a lot of the same issues you were experiencing. Thank you very much for documenting this. I want to know if my factory axles can be rebuilt?
did you check the CV axel teeth themselves before putting on the new flange. Because if the teeth are tore on the CV axel you only solved half the problem
This has been a very helpful video, thanks! Excuse my ignorance, but are these flanges only on the front axels? Also, would you include the part numbers for the flanges and the gaskets? Thanks!
Great video, and I can't help to noticed you have a diffrent set of rims on your 100 series Landcrusier. How did you get them to fit. I also have the same rims but I can't get the center hub cap to fit flush.?
They are 200 series rims and I didn’t have to modify anything for them to work.
This was a super helpful video in giving me clues on what could be causing my LX470 to have a lot of the same issues you were experiencing. Thank you very much for documenting this.
I want to know if my factory axles can be rebuilt?
did you check the CV axel teeth themselves before putting on the new flange. Because if the teeth are tore on the CV axel you only solved half the problem
I ended up replacing them as well.
Great. Thank you.
It’s so common I think it’s just an inherent problem for the LC100. I tried greasing the drive shafts and zero difference on mine.
Thank you! Hopefully I can figure something out. Regardless not happy with CV spline engagement.
Would excessive differential backlash contribute to the clunk?
Yes sir I think that might be part of my problem.
whats the part number? thx
Hello sir.. how many teeth (flange) are there sir?
Two? One per side unless your asking the number of teeth on each then I’m not sure.