My router is OPNSense. I have a TPLink switch between the Router and the 9800-CL. I can get the plan set up and clients to connect but cannot get them to have IPs assigned by OPNSense. Where might I be going wrong? Thanks!
Thanks for these videos mate. Quick question dont we need to provide option 43 for APs to get the controller IP address ? Also which Access point you are using
HI, This was the best video i have seen for WLAN, I have small issue with my Controller when i am using console I am able to go into into enable mode and configure mode but when i am trying SSH i am getting this error %Error in Authentication Can you please let me know what i can do to work in SSH
Hi, thank you so much. as far as I understod Interface eth0/0 where AP connected is a trunk or access with vlan 10 ? it should be access? Interface eth0/1 where WLC connected is a trunk definitly, with allowed VLANs 10 and 20
I can't thank you enough. I was literally struggling for this video. Finally found this. Gratitude 🙏.
Glad it helped!
best video about WLAN ever
Sir excellent way of teaching
Thanks and welcome
Please share cisco 9800- controller Flex mode configuration video and how to adjust RF parameters values in both2.4GHz and 5 GHz.. Good video 👌
Your support is 100 hundred times better than Cisco!
My router is OPNSense. I have a TPLink switch between the Router and the 9800-CL. I can get the plan set up and clients to connect but cannot get them to have IPs assigned by OPNSense. Where might I be going wrong? Thanks!
Thank you Sir,
Thanks for these videos mate. Quick question
dont we need to provide option 43 for APs to get the controller IP address ?
Also which Access point you are using
could know how to add AP cisco on EVE ?
how to make AP associated with WLC sir?
All to this day, I'm still waiting for someone to setup the WLC without using the wireless setup Wizard
HI,
This was the best video i have seen for WLAN,
I have small issue with my Controller when i am using console I am able to go into into enable mode and configure mode
but when i am trying SSH i am getting this error
%Error in Authentication
Can you please let me know what i can do to work in SSH
Hi,
thank you so much.
as far as I understod Interface eth0/0 where AP connected is a trunk or access with vlan 10 ? it should be access?
Interface eth0/1 where WLC connected is a trunk definitly, with allowed VLANs 10 and 20
Any videos on setting up ssl.
what is the default username and password on the C9800 on lab sir?
after the setup my radios go to up state for a sec then go back to down, any suggestion?
Check your country settings
I like your tutorial, thanks! Can you show how you configured your external switch (Link to Physical AP)?
Yes, soon
do you know hot to add new AP in EWC?
You didn’t show how to enable https management
Or how to configure the management vlan on first run!
Can anyone please tell me what image is used in the place of "Link to physical AP"?
what is the default username and password on the C9800 on lab sir?
Why you didn't assign ip address to vlan
Vedio is really good but this background music is so annoying
Hey, can you share the best practice config for 5Ghz and 2.4 Ghz, please?
I can assume that this is the "Typical" RF config you mentioned.
Thanks for this video.
Clear
Concise
To the point
Nice music
Can you make a web authentication video please
Great. Thanks
Thank u Bro !