What's the advantage of using the hole wizard before threading, rather than extrude cut a simple hole? It would be nice if it created the threads automatically, but it doesn't. Also, it should be "Cut thread", instead of "Extrude thread". The initial hole was already smaller than the nominal value, so that the thread is 'cut' to size. But for some reason !Cut thread" option doesn't work. Another issue is that I have many holes to tap and the wizard doesn't allow me to tap all. Just one by one. Either I'm missing something, or the wizards sucks.
Biggest problem with video is that the 1st Hole Wizard thread was set to an M20 x 1.5mm thread. Then the Internal Thread Feature was made using a setting that looked like M8 x something. What gives?
This feature is tricky because it has both extrude and cut options, but at the same time you must select die or tap. If you are in a hurry you may accidentally select conflicting options. Shouldn't SW be smart enough to limit your options and prevent conflict.
This lecture is very nice sir
What's the advantage of using the hole wizard before threading, rather than extrude cut a simple hole? It would be nice if it created the threads automatically, but it doesn't.
Also, it should be "Cut thread", instead of "Extrude thread". The initial hole was already smaller than the nominal value, so that the thread is 'cut' to size. But for some reason !Cut thread" option doesn't work.
Another issue is that I have many holes to tap and the wizard doesn't allow me to tap all. Just one by one.
Either I'm missing something, or the wizards sucks.
It won't thread an extruded cut, unfortunately!
You save my life
Very weldon sir
awsome i see another channel so complicated dan hard to understand
It will not let me choose the end condition to be the 2nd edge, why is that?
if i have a bolt or threads, how can i know what the dimensions are? how do i dimension threads in SW?
TNX
this shall be Metric Tap + Cut thread for holes
Awesome. Really helpful. Regards from Costa Rica
Biggest problem with video is that the 1st Hole Wizard thread was set to an M20 x 1.5mm thread. Then the Internal Thread Feature was made using a setting that looked like M8 x something. What gives?
Same question
Should use metric tap, this is female thread
Awesome tutorial, but I have a lot of holes and can't figure out how to thread / tap multiple holes
Why I can't find thread on features? any solution?
click on the small arrow below hole wizard in features tab ,u will get it over there.
Thank You! Thank You Thank You Thank you.. did I mention Thank you?
yes
Hii ajaybhai 👍🏻👍🏻👍🏻
😎
Why do all other videos make it look so hard?
This feature is tricky because it has both extrude and cut options, but at the same time you must select die or tap. If you are in a hurry you may accidentally select conflicting options. Shouldn't SW be smart enough to limit your options and prevent conflict.
this no longer works, dont waste your time.
to fast with no description and bad music....good luck beginners
Version year
2017
Nice trojan bro lol
That looks like shit.