Це відео не доступне.
Перепрошуємо.

Solar Battery Bank Monitor with Shunt Installation LiFePO4

Поділитися
Вставка
  • Опубліковано 15 сер 2024
  • Installation of Spartan Power DC Meter Battery Monitor & Multimeter 0-300A 0-200VDC LCD Display
    Comes with 300A Current Shunt and Wiring Kit

КОМЕНТАРІ • 23

  • @MrPenguinLife
    @MrPenguinLife 2 роки тому +9

    I am the only one that cringed every time he sat the wrench down on the batteries?

  • @justinnewman5533
    @justinnewman5533 Рік тому +2

    the battery power indication of this device is linear but lithium batteries are not. it means the indicator will show its full for a long time then it will suddenly drop.

  • @buckyflex1
    @buckyflex1 Рік тому +1

    800ah of lithium, as a car audio guy I'm salivating over here.lol

  • @whitenas
    @whitenas 2 роки тому +3

    Good video. Can you make one of the programming of the monitor

  • @bradleybarker4268
    @bradleybarker4268 8 місяців тому +1

    Why is half your canopy full of battery's ? Where does your stuff go ?

  • @justinchisholm9563
    @justinchisholm9563 7 місяців тому +1

    Hi i found these great but when uding battery charger and charger turns off after reaches full charge
    It kills the monitor
    Any thing that can be done
    Works fine if stop charger before it reaches full charge

  • @Jays1ndone
    @Jays1ndone Рік тому +2

    Just FYI, DO NOT use that inline circuit breaker (use a fuse), it causes a voltage drop across it. I had one going from the charge controller to the batteries and my batteries never fully charged as it had a 2v drop across that inline circuit breaker.

    • @justinnewman5533
      @justinnewman5533 Рік тому

      just fyi, its a shunt, not a circuit breaker. its supposed to have a small voltage drop if you draw current so you can measure power. if you dont use the shunt, it cant measure power. and it is small if you use the correctly rated shunt.

    • @Jays1ndone
      @Jays1ndone Рік тому

      @@justinnewman5533 2:15 is the circuit breaker and WILL have about a 2VDC drop across it, the shunt is fine, the circuit breaker at 2:15 is going to screw things up.

  • @yzf40
    @yzf40 Рік тому +1

    Le shunt ne le laisse pas poser sur ta batterie fixe le sur le mur il risque de chauffer et abîmer ta batterie

  • @pcmontgo8629
    @pcmontgo8629 3 роки тому +1

    This is in an informative video!

  • @DeekJohnson
    @DeekJohnson 2 роки тому +1

    Hello, any updates on this battery monitor? Accurate? Would you recommend? Thx

    • @thervsolarseries2827
      @thervsolarseries2827  2 роки тому +1

      The only issue I have with this monitor is the connections for the wires is not very secure. They could easily vibrate out. Other Tun that I have no issues with its operation.

  • @superformOG
    @superformOG 2 роки тому +2

    gives me anxiety watching you with that spanner so close to uncovered terminals

  • @peace7267
    @peace7267 6 місяців тому +1

    mate theres a lot of things wrong here,

  • @kevin83FL
    @kevin83FL 2 роки тому +1

    At the 6 minute mark, I almost peed my pants from that positive wire a few times. I know it is a tiny wire, but Jesus! Lol. Great video btw.

    • @thervsolarseries2827
      @thervsolarseries2827  2 роки тому +1

      Living life on the edge! Ah it might spark a little but that would be about it.