Invertek Optidrive E2 Guide Part 1 - Install

[@pampannachikalaparvi4636]

Thank you sir

[@CoolClassicMusic]

What is the Ohm range of the potentiometer that you used? Thanks.

[@elfercho1]

Muy buena ayuda para la puesta en marcha de los equipos Invertek E-2, estos variadores los puedes conseguir en la empresa Electromecánica y Soluciones Industriales en Medellín -.Colombia

[@iSherifs]

Yes, this was useful!

[@jorgeastete3860]

YO LO TENGO EN LIMA PERÙ
MUY BUENO EL VIDEO (Y)

[@javalearner4227]

I am new to LabVIEW program and trying control the variable refrigerant flow compressor speed through LabVIEW program. Using the following LabVIEW functions and hardware..
TCP Open connection: IP address has been defined in the TCP open connection.
Speedy: (driveweb.com) : This speedy device is connected with network card using Ethernet cable.
OPTIDRIVE E : This device controls the ‘Variable Refrigerant Flow” compressor speed(manually and based upon LabVIEW written program). This device is connected to network card through speedy by using Ethernet cable.
Hardware configuration:
OPTIDRIVE E ( IP 20 & IP66 (NEMA 4X) AC variable speed drive ( 0.37 - 11 kW) ( 110-480 V)
Confirmed: Its been confirmed that Speedy is communicating with CPU.. I have ping the IP address and it responded.
Questions:
1. What signal should I send to OptiDrive E in order to switch on/off the compressor motor?
2. Has anyone tried this before?

Any help will be appreciated !
Thanks!

[@pampannachikalaparvi4636]

Thank you sir