Nicely done! Thanks for sharing. I'm working on a LS swap, and if it ends up with the stock computer, might be looking to do just this. Of course, if I end up using the Megasquirt that's been sitting on the shelf for longer than I've had the LS1, it's a moot point as it can directly drive it, but eh...
@@aknovaman what material do you plan to print it in? I moved to the Southwest and found that my automotive PETG prints really didn't like the ambient temps out here, while the prints were fine in the Northwest for a couple of years prior.
awesome. can you share your code? works for all pwm fans? is your code just a two setting speed control for switched grounding from the temp sensors? or how is it signaled?
Nicely done!
Thanks for sharing.
I'm working on a LS swap, and if it ends up with the stock computer, might be looking to do just this. Of course, if I end up using the Megasquirt that's been sitting on the shelf for longer than I've had the LS1, it's a moot point as it can directly drive it, but eh...
check back with me when ready. I plan to 3D print a case for it.
@@aknovaman what material do you plan to print it in?
I moved to the Southwest and found that my automotive PETG prints really didn't like the ambient temps out here, while the prints were fine in the Northwest for a couple of years prior.
awesome. can you share your code? works for all pwm fans? is your code just a two setting speed control for switched grounding from the temp sensors? or how is it signaled?