929 Build Video

Order Your DR_XR 929 Here: drcare.us/prod...
A Dr. Care massage Chair is the best way to live life a little better every day.
Make sure you follow along in this video as we walk you through the building process for the 919x Space Ship Chair.
Dr.Care exclusively offers:
10-year warranty
30 Day free trial
30 Day money-back guarantee
Free Shipping in the U.S.A.
Dr.Care International Inc.
[phone]
6565 E. Washington Blvd., Commerce, California 90040
Subscribe to our UA-cam Channel: www.youtube.co....
Visit Our Website:
drcare.us
-Open by removing the top portion of the box from the blue base.
-Remove the two boxes inside (hardware & tablet arm).
-Remove the styrofoam side walls.
-Remove the plastic covering wrapped around the entire chair.
-Tilt the chair back and slide it off of the base.
-Get a friend to help you arrange it in its final resting place.
-Open the large brown box.
-Remove the headrest speaker from the box and plastic.
-Determine which speaker goes on what side.
-Align the speaker to the side you’ve chosen to start with.
-Plug in the white connector at the bottom of the speaker to the chair.
-Slide the speaker down into place and make sure the speaker feels secure.
-Open the small brown box.
-Locate the hardware in the box, it will be in a plastic bag.
-Separate the hardware by size.
-Identify what screws you need and install them into the correct holes.
-Identify the final hole on the inside of the chair at the speaker’s base and apply the -appropriate screw to tighten the speaker down.
-If you left any fingerprints on the chrome finish, you could easily wipe them away with a dry microfiber towel.
-Repeat steps 10-18 on the opposite side of the chair.
-Slide the footrest up to the front of the chair using the wheels on the corner.
-Identify the wire connectors and secure them together.
-Secure the airbag hose.
-Remove the corner covers from the chair.
-Using a screwdriver remove the hardware from the support peg latch and set it aside.
-Attach the footrest support pegs to the side of the footrest.
-Identify the grooves the chair’s footrest support pegs will be settling into and guide them into place.
-Close the latch and use the screw from before to secure the latch.
-Place the corner covers back over the pegs and latch.
-Identify what side panel you’d like to install first and remove it from its packaging.
-Look for the wires tucked into the side of the chair and pull out the connectors.
-Locate where the connectors go on the side panel.
-Bring the side panel as close as possible and connect the two wire connectors as well as the air hose.
-Align the side panel over the grooves and slots and let it slide down into place.
-Identify the hardware you will need for the side of the panel and the hardware cover.
-Slip the screw through the washer and tighten it into the center hole.
-Install the center hole cover.
-Identify the hardware needed and the screw hole on the inside of the chair.
-Tighten the screw down until snug.
-Inside the smaller brown box, you’ll find the tablet controller and the cradle.
-Find the wire connector on the base of the cradle post, and on the chair.
-Connect the wires together after removing the zip tie holding it in place.
-The cradle post has a groove find the groove and slide the post into the hole.
-Screw on the tightening washer and align the cradle into place.
-Drop the controller into the cradle.
-Identify the power cord.
-Make sure the chair’s power button is in the “OFF” position.
-Plug the chair into a safe power source.
-Flip the chair’s power switch to “ON”.
Your chair is now ready to GO!