@@MNDashcam Man... It was ready.. Had a BMW on there, I dropped it, and it was grabbing the rail on the lower part of radiator I guess.. And it pulled my pin right up and out. I liked ta shit. Pin was in good shape considering Bushing was still good. And yeah, I went to heningers, here,, 20 bucks each. two disc.. Greased and she's like new. Thanks buddy
@@MNDashcam Very true. Your video is the only one I could find. I've got an i500 and I'm told there's no more parts to be bought for it. So I need a Pivot Pin I guess. Pretty sloppy no disc on top or bottom leans hard. Still using it too. But not sure how to get out. NO bolts to be seen. top or bottom. had a plate on top made with four screws.bolts were.. Gone now.. My Bar is spread a tad.. But I think still good. Any suggestions on how to rig one.. Since I can't get get new? I'm thinking Bushings & Disc and put the same pin back in.
How can I get the disc to replace them?
And how do I get my pin apart without destroying it to reuse or can I?
Oh my W/l is a challenger/Miller
Zips is a good source for parts. They got what you need.
@@MNDashcam Man... It was ready.. Had a BMW on there, I dropped it, and it was grabbing the rail on the lower part of radiator I guess.. And it pulled my pin right up and out. I liked ta shit.
Pin was in good shape considering
Bushing was still good.
And yeah, I went to heningers, here,, 20 bucks each. two disc.. Greased and she's like new. Thanks buddy
Are u in Maryland ? I need my wheel lift repaired
I am not
MN dash cam? im guessing Minnesota? what city?
I'm s minneapolis
just seen your profile pic looks like its taken from the powderhorn area
Minneapolis and St Paul mostly but I am all over the place
@@MNDashcam ya i was up until recently driving for Metro Mobility and seen lot of bad driving lol
The profile pic was taken on 94E in St Paul right before the 35E entrance. That ramp that curves left and down. Constant crashes there.
Dam I just got a wrecker I think I'm just have to change it completely because of what they did because those bushings worn out
A neglected wear item. You get more lift an control when the arm isnt floppy
@@MNDashcam Very true. Your video is the only one I could find. I've got an i500 and I'm told there's no more parts to be bought for it. So I need a Pivot Pin I guess. Pretty sloppy no disc on top or bottom leans hard. Still using it too. But not sure how to get out. NO bolts to be seen. top or bottom. had a plate on top made with four screws.bolts were.. Gone now.. My Bar is spread a tad.. But I think still good. Any suggestions on how to rig one.. Since I can't get get new? I'm thinking Bushings & Disc and put the same pin back in.