I am still running plasmacam 3.11 and there is no auto for AVS. I went from the 1.153 default to down to 1.087 then up to 1.4 in steps of 0.07 and then stepped back down to 1.26. At the default the tip was diving into the material some. This seems good and I use drill bits for height check (1/16" for cut height) HT PM 65 torch. PlasmaCAM did a CRAP job of explaining the AVS; you did way better.
Thanks for videoing something that should be more clear in plasmacam's "video manual"
Thank You! Plasmacam doesn't support my 3.11 software anymore but I was able to figure it out with your help! THANKS AGAIN :)
I still use PM 3.11 too. I have DE but afraid to commit to it since 3.11 is so practical.
FYI people, this is Plasmacam Design Edge.
I am still running plasmacam 3.11 and there is no auto for AVS. I went from the 1.153 default to down to 1.087 then up to 1.4 in steps of 0.07 and then stepped back down to 1.26. At the default the tip was diving into the material some. This seems good and I use drill bits for height check (1/16" for cut height) HT PM 65 torch. PlasmaCAM did a CRAP job of explaining the AVS; you did way better.
super helpful. Thanks for the info.
Thanks very much for your help.
Im glad it helped you out!
Which software is that
Design Edge