Oh shit, I just bought one of these for my LVOA-S. Small little things. You can barely tell it's there with the LVOA rail system. Sorta like a replacement tophat that makes your bbs turn green.
@@thelethalpredator672 That is the acetech blaster. I have a buddy who got one of those recently. Theyre about 20 bucks more and other than the simulate barrel flash work about the same.
Very good tracer, led strips are located on both R/L sides. BUT... wish it also had a on/off switch, this way I'd leave it permanently attached to my gun. And the front cap is plastic, doubt it would survive BB hits for long.
@@1GLO919 it has been holding up really good between using it with my Hicapa and my Raven Elite, and my son has also been using it with my Hicapa on HPA …
An inner barrel that is too long will probably interfere with the sensors in the unit. Contact tech@evike.com for assistance with finding the correct length barrel for you.
Now I need that tracer with the fake muzzle flash to be made in this small form factor and then I'm going to buy one hehehe. GBBR with that fake flash without looking to bad would be such a blessing
Only thing you haha to look out for is some tracers with muzzle flashes have the light exposed and then can be shot out by bbs. They also look better with gas blow back guns.
hi can it use with Tokyo marui M92F CHROME STAINLESS VERSION? Because there is not screw on the end of the gun. If you know please tell me at thank you very much
anyone know if the long tracer ones work with pistols? on amazon it says only the short ones work with pistols. I have a USP that I want to add a long tracer too.
2 years ago but hey. I use the Acetech 1000 for all my guns. But my pistol has outer threads not inner. I dont believe it came with an adapter for inner threads. That may be what they are referring to, the adapter. 14CCW to 11CW/CCW
This will not break as a result of using it on any airsoft replica with -14mm threads, as far as we are aware. Why would it break from the Calico Jack?
There is a sensor that detects a BB and activates an LED flash to make the BB glow (only works with special glowing BB's called 'tracer' BB's) The unit is battery powered and rechargeable.
@@chibispartanch.2380 I came here to see some interesting comments. But nowadays there are always some losers like you who (for some reason) claim to be the first to comment, instead of doing some productive of your day.
![Lp. Сердце Вселенной #60 РОЖДЕНИЕ ЛОЛОЛОШКИ [Финал] • Майнкрафт](http://i.ytimg.com/vi/YoR0pAV9FVQ/mqdefault.jpg)
Oh shit, I just bought one of these for my LVOA-S. Small little things. You can barely tell it's there with the LVOA rail system. Sorta like a replacement tophat that makes your bbs turn green.
Works like a charm on my WE Hi-capa
I have a couple of these and they are awesome!
Arnt these the ones that simulate muzzle flash? If so might be my first tracer unit, I already have an Acetech chronograph they are a good brand
@@thelethalpredator672 That is the acetech blaster. I have a buddy who got one of those recently. Theyre about 20 bucks more and other than the simulate barrel flash work about the same.
Apparently some fields don't allow them because it can kinda be a strobe light if you're shooting rapidly. Just a heads up.
Evike, I purchased one of these and the plastic threading totally shattered. No impacts or abuse. It didn't like my TM 4.3 hicappa.
Please get in touch with our Customer Service department -
support@evike.com
(626) 286-0360
7:00am to 5:00pm PST Monday through Friday
Very good tracer, led strips are located on both R/L sides. BUT... wish it also had a on/off switch, this way I'd leave it permanently attached to my gun. And the front cap is plastic, doubt it would survive BB hits for long.
I have multiple hits so far running Pistol and the shake on is great less parts to break
@@adrenalinowner7992 how is it holding up?
@@1GLO919 it has been holding up really good between using it with my Hicapa and my Raven Elite, and my son has also been using it with my Hicapa on HPA …
this one's threads are plastic unlike the other ace techs I have & today I unscrewed the back cap to find the threading totally shattered. Disapointed
@@TrafficCones ur using it wrong
Will it fit a Glock 17 gen 4?
Make a video putting it into a mock suppressor!
AceTech actually has a mock suppressor that includes the Brighter C. It's called the Predator MkII.
Got one yesterday from a local indoor arena. Wasn't able to use it since my rifle was 20 over the fps limit
It's nice, I put the Predator mkII on my snow wolf a2 aug
Why did you put me on your gun?
@@thelethalpredator672 to make it that much cooler obviously
Since it works on the kwa eve 9 will it work on the 4??
What happens if my barrel is a few more too long? I’m getting constant beeping
An inner barrel that is too long will probably interfere with the sensors in the unit. Contact tech@evike.com for assistance with finding the correct length barrel for you.
I use this for both Green and Red Bbs
Now I need that tracer with the fake muzzle flash to be made in this small form factor and then I'm going to buy one hehehe. GBBR with that fake flash without looking to bad would be such a blessing
The Acetech blaster is just barely bigger than the brighter C and has exactly what you asked for.
Only thing you haha to look out for is some tracers with muzzle flashes have the light exposed and then can be shot out by bbs. They also look better with gas blow back guns.
hi can it use with Tokyo marui M92F CHROME STAINLESS VERSION? Because there is not screw on the end of the gun. If you know please tell me at thank you very much
I can't put it on the vector, even if I remove the highlighter tip
Will it work on my TM Hicapa 5.1?
This will work on my G&G cm 16 raider. Correct ?
Correct.
I love mine!
is this compatible with a glock 17 gen 5? btw its co2 idk if that matters but yeah
I love mine I only charged it twice since I had it only 2 mouth
anyone know if the long tracer ones work with pistols? on amazon it says only the short ones work with pistols. I have a USP that I want to add a long tracer too.
2 years ago but hey. I use the Acetech 1000 for all my guns. But my pistol has outer threads not inner. I dont believe it came with an adapter for inner threads. That may be what they are referring to, the adapter. 14CCW to 11CW/CCW
I’ve heard Ace tech tracer units are amazing
Generally they are but this one isn't very good.
@@TrafficCones What's your issue w/ it. I found one online from like $36 but I'm debating if it's worth it. I'm new to the Airsoft world btw.
For $55 I might put this on my tti 1911 combat master
I heard that this would break when put on a matrix calico jack, is that true?
This will not break as a result of using it on any airsoft replica with -14mm threads, as far as we are aware.
Why would it break from the Calico Jack?
Do I need to take my orange tip off for this?
wil it work with most rifles or dose it need to be specific
This will work with airsoft replicas that have -14mm threading on the muzzle.
Do you have to use special BBs with this on the phosphorus BBs
Tracer BB's - www.evike.com/shop/28/27/529/
Will it fit into a regular glock holster?
Maybe if you cut a hole at the end
It is still not recommended to hang something on the end of a tilting (airsoft)barrel.
Where did you guys get the rifle)
Available on our website! - EMG / KRYTAC / BARRETT Firearms REC7 DI AR15 AEG - www.evike.com/products/19167/
Do they make these for real pistols ?
What? Why? You're gonna light up you 9mm?
What handgun is that??
Archon Firearms Type B - www.evike.com/products/13770/
Does anyone know if this fits on a elite force m4 cqc mlok
This will fit any replica with .14mm threads.
What pistol is that?
Archon Firearms Type B - www.evike.com/products/13770/
How do they work
There is a sensor that detects a BB and activates an LED flash to make the BB glow (only works with special glowing BB's called 'tracer' BB's)
The unit is battery powered and rechargeable.
I want one of those for my toy guns
tracer units
Yeah buy this and another 4 parts just to use the thing
please mute the music next time, it was hard to understand what he was trying to say.
👍👍👍👍👏🏻👏🏻👏🏻👏🏻
Gimme!
🇧🇷🇧🇷🇧🇷🇧🇷
First I guess
What if I told you that even though you were first…
You are still a loser!
@@Wichelroede arent we all losers?
@@chibispartanch.2380 Why would I be a loser, for instance?
@@Wichelroede because you spend your time randomly harassing people on the internet instead of doing something productive of your day
@@chibispartanch.2380 I came here to see some interesting comments.
But nowadays there are always some losers like you who (for some reason) claim to be the first to comment, instead of doing some productive of your day.