SUPER EASY Homemade Bearing Puller
Вставка
- Опубліковано 21 жов 2024
- My circular saw had a faulty bearing that needed to be replaced. It was stuck and I didn't want to damage the shaft so made this puller.
For this you only need a piece of square steel tubing and some nuts and a bolt.
You're also going to need some common tools like a hacksaw, hand drill, wrench, etc.
The best part about this is that you don't need to weld any parts!
I hope this video helps you too.
like and subscribe if you want to support my channel.
tip: make sure you don't overheat your electric tools when using them, otherwise they may end up like this saw with a burnt bearing.
#diy #tool #repair #woodworkingtools #makita #circularsaw #toolmaking #homemade #bearingpuller #bearingremover
Thank you sir for share this idea!! It worked great!!
@@JohnRoyala thank you 🙏
Amazing idea! From the most basic materials available. Thank you! Now I can finally extract the bearing out of the charger's rotor!
Glad it helped!
That is absolutely genius!!!! Thank you for the video.
Thank you :) Glad it was helpful
SPECTACULAR VIDEO ! 😊
Amazing tutorial ! 👍
Best regards ! 😛
J H 🇩🇰
@@jurgenhelgen212 Thanks a lot 🙏
Great job
nice easy build to pull a bearing !
Hello,
Thank you for your video.
Another idea which helps for miniature projects.
Thank's a lot.
Hi, thanks for watching 🙏 I'm glad it was useful.
very nice
i like it. well done
That’s so helpful!
This is what i am searching for..
Thanks
Happy to help
good idea. i will use it.
Very simple and efficient. 🙏
Thanks 🙏
Thanks brother very good I am very happy God bless you
Thank you too :)
Very easy and good idea brother
Thank you :)
Perfect. Thank you!
You're welcome!
Great idea and video. I have a pedal that has a date with your tool.
Thanks! I hope it works out for you :)
SUPER 👍 💪 ✌ 🤝
Wao! No welding plant required 🥽👍
Very nice
🙏
Thank you very much
You are welcome :)
Excelente
Saludos!🇲🇽
Thanks! :)
Better and more practical is welding two nuts,👍🇧🇷
❤❤❤
👍
weld the nut so that it stays more fixed and not use that screwdriver as a wedge.
Thanks
one of my goals was to make it very simple and without the need of a welder.
I'm at that point where, I'll just cut the bearing off
@@obviouslytwo4u sometimes that is the only way. Good luck