Aqui no Brasil os eletrodos E-6010 são feitos com essa cor para diferenciar dos outros. Não é uma norma oficial, apenas uma mera prática dos fabricantes.
6010 for the root pass, then 7018 for filling and capping, great combination. 6011 will make an excellent job too for the root pass, plus it's a bit easier to work with than the 6010.
@@ykcajkom687 6010 and 6011are cellulosic coated rods, 6013 is a rutile coated one. 6010 and 6011 have better penetration in the root and work much better on a not perfectly clean base metal. Plus they have better mechanical properties and allow to use a slightly lower welding current than others, which reduce the thermal affected zone. However, not all welding machines can properly weld with those rods. You need a OCV at least 85 volts and to set correctly arc force parameter to get good results.
Tremenda tecnica para soldar!! Muy bueno!!! Feliz navidad Elosta!!
Muy feliz navidad 🎄 desde buenos aires argentina 🇦🇷 .
Muy bueno el proceso de raíz y relleno con 7018
Welding pipe from the inside, that's trippy
Saludos maestro buena tecnica
Jerja yang sangat bagus 👍
100% ваши руки ростут не из жопы. 👍
تحية طيبة. . ليش الالكترود احمر .
Aqui no Brasil os eletrodos E-6010 são feitos com essa cor para diferenciar dos outros. Não é uma norma oficial, apenas uma mera prática dos fabricantes.
عمل عظيم
Салам.Крассиво вариш только не показываеш на каком токе и диаметр электрода.
Lezgov❤
Which type electrode is this?
6010 for the root pass, then 7018 for filling and capping, great combination.
6011 will make an excellent job too for the root pass, plus it's a bit easier to work with than the 6010.
@@luillierstephane1463 what difference in 6010 and 6013?
haven't use 6010 before
@@ykcajkom687 6010 and 6011are cellulosic coated rods, 6013 is a rutile coated one.
6010 and 6011 have better penetration in the root and work much better on a not perfectly clean base metal.
Plus they have better mechanical properties and allow to use a slightly lower welding current than others, which reduce the thermal affected zone.
However, not all welding machines can properly weld with those rods. You need a OCV at least 85 volts and to set correctly arc force parameter to get good results.
Good work👍👍 i am also have thi type welding channel plz support 🙏