Hello my name is Brandon and I work for a company and I mainly in the dishroom and I have the exact same style as setup pre-rinse nozzle I have a question is it possible that limescale or hard water buildup could it cause it to lose pressure
i have one and the pre-rinse sprayer won’t shut off. is there a spring in that bonnet valve that needs to be replaced in order for it to shut off instead of staying on, or should i just replace the entire bonnet valve?
i used a rebuild kit with new springs and o rings. the spray nozzle leaked worse after i fixed it. i'm guessing that the corrosion inside the spray assembly prevented a secure seal. if you can't remember the last time the handle was serviced (longer than ten years), it may be better to replace the entire handle because of build up calcium/lime/oxidation
WHO MAKES ONE ALL METAL AND NOT OF RUBBER OR PLASTIC THAT ONLY LAST 4 WEEKS IF THAT? THE ONE DISPLAYED ABOVE PUTTING IT BLUNTLY SUCKS ASS .A WASTE OF MONEY.IT LEAKS AT EITHER THE FACE OR THE PART THAT HAS SCREW IN MIDDLE CRACKS .EITHER WAY IT SUCKS.
the chances are good that you are over tightening. hand tighten, then go 1/8 using screwdriver or wrench. then, if it leaks, tighten another 1/8 turn. use stepwise refinement. these sprayers are commercial grade. use a professional installer
I dont have a leak but a sudden drop in pressure on at this sink. Others on the same line work fine. Any ideas?
Thank you for the video, we've had a leaky sprayer at our restaurant and this video helped me to get it fixed, thanks a bunch!!!
The part that you unscrewed, that button when you squeeze the trigger gets stuck, is it because of calcium buildup? Will CLR fix this?
Is there a way to adjust the stream flow on the pre rinse sprayer?
Hello my name is Brandon and I work for a company and I mainly in the dishroom and I have the exact same style as setup pre-rinse nozzle I have a question is it possible that limescale or hard water buildup could it cause it to lose pressure
i have one and the pre-rinse sprayer won’t shut off. is there a spring in that bonnet valve that needs to be replaced in order for it to shut off instead of staying on, or should i just replace the entire bonnet valve?
Hey you ever figure it out ?
i used a rebuild kit with new springs and o rings. the spray nozzle leaked worse after i fixed it. i'm guessing that the corrosion inside the spray assembly prevented a secure seal. if you can't remember the last time the handle was serviced (longer than ten years), it may be better to replace the entire handle because of build up calcium/lime/oxidation
Can i buy parts from you? I saw how can the spray can be repair at my restaurants i need to fix them
Thanks You have been a big help
Why is a brand new spray spewing out if the front rubber nozzle. I need answers immediately
tough question. what did you do to fix it
Very helpful tips
I can’t seem to get the handle to tighten back up.
WHO MAKES ONE ALL METAL AND NOT OF RUBBER OR PLASTIC THAT ONLY LAST 4 WEEKS IF THAT? THE ONE DISPLAYED ABOVE PUTTING IT BLUNTLY SUCKS ASS .A WASTE OF MONEY.IT LEAKS AT EITHER THE FACE OR THE PART THAT HAS SCREW IN MIDDLE CRACKS .EITHER WAY IT SUCKS.
the chances are good that you are over tightening. hand tighten, then go 1/8 using screwdriver or wrench. then, if it leaks, tighten another 1/8 turn. use stepwise refinement. these sprayers are commercial grade. use a professional installer