Panasonic RX DT 75 how to repair COBRA mechanism
Вставка
- Опубліковано 15 вер 2024
- full service for Cobra mechanism, PROBLEMS: failed to open ,close all the way ,getting stuck, very hard to open manually, intermittent failure ,,SUBSCRIBE ,LIKE,SHARE,COMMENT, ENJOY
Ótimo trabalho 🙏🏼😀
Thank you very much, more videos on the way,just now I finished assembly back together the Cobra and I prepared a little surprise for you,new video coming soon
molto meglio i video senza la musica di sottofondo e le scritte che mettevi prima.. e mi piace molto che fai vedere tutto il processo di restauro dall'inizio alla fine... anche se i video durano di più, a mio parere, sono più interessanti.
BRavo!!
Thank you very much for your support,. I glad you like the new form, more videos like this on the way , Thank you again for feedback
Подскажите пожалуйста, после замены фетровых прокладок, козырек заработал в штатном порядке без лишних хрустов и прокручиваний в нутри шестеренок?
When the unit is open for repair noise from cobra gears is present,if it remember correctly, only for opening, i grease everything I adjusted the axle but the noise is there only when the unit is open , I think this is normal operation, my advice is clean,grease, and if you repair the clutch every thing is going to work a long time , good luck with your project
@@blingonit спасибо
Ни чего больше за кадром не дорабатывали?
Good question,,, yes later on because the unit is heating up right below the cobra mechanism,and the unit is not seated on flat surfaces, a problem developed, the clutch slips and cobra has trouble opening or closing it needed a little help , as soon as the unit cools down everything is ok , so i open the clutch assembly and add a drop off steaky white grease , like the cassette tape open door delay mechanism,everything is working perfectly now