Astra - Indicator & Brake Light Fault - Problem Found & Fixed - How To DIY
Вставка
- Опубліковано 26 січ 2024
- In this video I show a Vauxhall Holden Astra K that has check brake light and check right rear indicator lamp warnings on dash with no working right hand brake light or right hand rear indicator light when visually checked.
After closer inspection I was able to see heat damage on the connector and the bulb / globe holder pin damaged. If you have this fault check that your wiring and terminal tension is ok before reinstall, if you have a burnt wire or damaged terminal this fault will not be solved without additional repairs including wiring repairs. This was not needed on this vehicle.
Thanks to everyone who watches my videos, Likes, Shares and or leaves a comment. I appreciate everyone of you.
Tool options that I recommend and use. www.amazon.co.uk/shop/gerardb...
➢ For business inquiries Email : gerardburkebusinessinquiries@gmail.com
Disclaimer:
GerardBurke is a qualified motor technician who has completed modules & courses in manual handling and all aspects of workshop safety. These videos are not intended to be used by anyone who is not trained and or qualified to carry them out.
Due to factors beyond the control of GerardBurke, I cannot guarantee against improper use or unauthorized modifications of this information. GerardBurke assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. GerardBurke recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of GerardBurke, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not GerardBurke.
How to replace the brake light bulb globe on a Holden Astra k B16
How to change the rear indicator light bulb globe in a 7th gen Astra
Engines this model comes out with
2015-2019
Petrol:
1.0 L GM SGE turbo I3
1.4 L GM SGE I4
1.4 L GM SGE turbo I4
1.6 L GM MGE turbo I4
Diesel:
1.6 L GM MDE turbo I4
1.6 L GM MDE twin-turbo I4
2019-2021
Petrol:
1.2 L LIH turbo I3
1.3 L L3T Ecotec turbo I3
Diesel:
1.5 L F15DVC turbo I3
Opel Astra
Vauxhall Astra
Holden Astra
Buick Verano Hatchback/GS
2015 2016 2017 2018 2019 2020 2021 2022
#Astra #brakelight #indicator - Авто та транспорт
This was a very simple find and fix on this vehicle but I have found out additional information for my viewers that may help you.
This fault is quite common to these models of Astra's.
*Check connector for terminal tension / damage
*Check wiring for heat damage / high resistance heat fault
This is a common practice with any auto electrical damaged components including headlight assemblies but on these models wiring looms may need repair also.
If there is excessive damage on the wires or at the connector you will need to repair that as well. I have in the past sourced connectors and wiring from scrap / wrecking / junk yards. You can also buy wiring kits for a complete repair if needed.
After any repair check powers and grounds at the connector for confirmation of a successful repair.
After checking bulbs fuses etc saw your video and found exactly what you said .only problem i had was with the new gasket so reverted to fitting the old one. you saved me a lot of money
💪💪
Just like to say thanks as just looked at my assembly and it was exactly the same thing a broken pin so have ordered a new one 👍🏻
Exact same fault, great video, saved me a few quid
Brilliant video, thanks 👍🏼
I had an issue with my brakelight on my astra. I watched your video and went and had a look, but it wasn't the same issue, but I think an issue with the wiring - however I have somehow fixed it, and without your video I wouldn't of bothered trying so thanks!
👌👌✅
well, tell us! :D
What was the issue?
Thanks for the video!
♥♥🙏🙏
Great job Gerard👌👍🙏🙂
❤️❤️ Thank you Pat 🙏🙏🙌🙌
Has the same problem we change this parts, is it working outside but dashboard still showing failure and with the same sound
Connector ?
The connector is where the wires push into. You would either de-pin the connector or replace it completely if you have wiring or terminal related faults. If the connector is not melted and it's reusable you can do whichever you prefer.