Wouldn’t the crossmember need to have a little hump in the middle to raise the drive shaft where the bolts go into the cross member? I’m about to make one like yours but all the cross members I’ve seen have a 5-6” hump in the middle to raise the drive shaft
yo bro so what all do i need to make a nbs extended cab fit on a nnbs crew cab , i know i need the 2pc driveshaft of extended cab but what u joints and yoke ?
Wouldn’t the crossmember need to have a little hump in the middle to raise the drive shaft where the bolts go into the cross member? I’m about to make one like yours but all the cross members I’ve seen have a 5-6” hump in the middle to raise the drive shaft
What I joint did you use? I’m having problems with my swap rn because the new u joint I put in is too big for the yoke on the rear end
you probably used a 1310 to 1350 u joint ? you need to get a 1310 u joint on all 4 sides
yo bro so what all do i need to make a nbs extended cab fit on a nnbs crew cab , i know i need the 2pc driveshaft of extended cab but what u joints and yoke ?
whats the nut size for the carrier bearing?
need some oil on that drill bit
Would you happen to have sizes on anything that was fabricated need to get this done for my crew cab
Hey I have a question on the driveshaft, I got the same truck same year and everything but the extended cab 2 piece fits the crew cabs?
Yes they do making the crossmember the hardest part
You think you can make me one and install it I’m in az ?
Would this work for a lowered 2001 Silverado for a 8 inch drop I’m having vibrating issues nd the drive shaft straps broke on me before
Yes does it have a two piece drive shaft already? Or a single
I have a 09 sierra crewcab, would those fit for the older years
Has to be from 99 to 07 extended cab Silverado or Sierra. To fit. My is a 2007 nnbs and has one out of a 2003 Silverado extended cab truck
It’s that drive shaft are you using will work on a 08 Silverado with out do any mods to the shaft
Yes I have the same one on my 07 nnbs
Thanks for that help ,I blow my drive shaft this weekend
Do you know the measurement of that crossmember?
i never took them down sorry
Where you get the steel tubing at ?
you can order it or if you have a local metal company just ask about square tubing
@@GBP_Vlogs if you can make a video that’d be cool ! Thank you bro
Si tienes las medidas del plato
Do you have a template for the cross member
No I never made one
Would a 99-06 2 piece shaft fit my 2008 5.3 Crewcab if I got a 4L80e Swapped into it?
Yes just change the slip yoke to shorter one
Sikk
thanks man
Just put a new one piece driveshaft