Two reasons I want to go to a leather console cover... 1) the rubberized stuff starts pulling the hair on my arm so after 20-30 minutes it gets painful. 2) damn dog scratched it up.
Hi Brian: Also, can you please give a tip about what's going on with the left hinge and parts? It looked like a half-moon with channel to prevent over-movement. Finally, what about the spray you used? Was that contact glue, or lubricant, and if so, what kind? Many thanks! Tim
Hi Brian: I wanted to thank you very much for producing this video - I have to do this in a couple weeks - so, again, thank you for doing this. It's helping guys like me with no experience. I believe I'll be OK by going slowly. I have all the tools you do for the job. I do have one question - that wrinkled corner of the first piece you did - will that eventually fill in - and if not, would steaming help? Many thanks in advance; I'm trying to gain as much knowledge as possible before I embark on this odyssey. Lastly, I have the two-piece model...I'm assuming I can just opt out of any other extra steps? Please advise if not. Thanks Brian!
I need a new chrome latch do you possibly know the part number for that model you took apart mopar keeps giving me the wrong part number
Two reasons I want to go to a leather console cover... 1) the rubberized stuff starts pulling the hair on my arm so after 20-30 minutes it gets painful. 2) damn dog scratched it up.
I would be very disappointed in the quality of the work of the cover. It shows obvious slack in the cover, should have been pulled tight.
Hi Brian: Also, can you please give a tip about what's going on with the left hinge and parts? It looked like a half-moon with channel to prevent over-movement. Finally, what about the spray you used? Was that contact glue, or lubricant, and if so, what kind? Many thanks! Tim
Hi Brian. Where did you purchase this cover? Or do you sell these?
Hi Brian: I wanted to thank you very much for producing this video - I have to do this in a couple weeks - so, again, thank you for doing this. It's helping guys like me with no experience. I believe I'll be OK by going slowly. I have all the tools you do for the job. I do have one question - that wrinkled corner of the first piece you did - will that eventually fill in - and if not, would steaming help? Many thanks in advance; I'm trying to gain as much knowledge as possible before I embark on this odyssey. Lastly, I have the two-piece model...I'm assuming I can just opt out of any other extra steps? Please advise if not. Thanks Brian!
What’s the brand of cover? Thanks
The camera movement on this is highly distracting! Just hold the camera still so we can actually follow what you're doing! Terrible camera work!