I just did my front bearings a few months back. When ordering the bearings, try to make sure the kit comes with a new bearing nut, or you'll have to make sure to use a different start on the threads so you can peen over a fresh section to lock it on. I took out the whole upright, loosened the back cover and nut, then sent it with the kit to a pro to press the old bearing out and new bearing in for me. Also regarding wheel/spring clearance, I run max negative camber on the strut topmounts, then use the crash bolts to add in positive camber until it's where I want it, and that pulls the wheel out from the spring a bit. Increases your scrub radius a bit, though, so check you're not rubbing on the rear of the wheel well on full lock. I run 215-40-17's
Also if you think that sound is bad, try driving around with the dust shield scraping on the rotor because you're a half deaf moron who can't hear good.
hey i just got my sw20, i noticed that you have a aftermarket steering wheel, does your horn work? i was looking to get it to, but is a little sketch to remove/cut cables any tips? thanks! :D btw love your sideskirts
I just did my front bearings a few months back. When ordering the bearings, try to make sure the kit comes with a new bearing nut, or you'll have to make sure to use a different start on the threads so you can peen over a fresh section to lock it on.
I took out the whole upright, loosened the back cover and nut, then sent it with the kit to a pro to press the old bearing out and new bearing in for me.
Also regarding wheel/spring clearance, I run max negative camber on the strut topmounts, then use the crash bolts to add in positive camber until it's where I want it, and that pulls the wheel out from the spring a bit. Increases your scrub radius a bit, though, so check you're not rubbing on the rear of the wheel well on full lock. I run 215-40-17's
Also if you think that sound is bad, try driving around with the dust shield scraping on the rotor because you're a half deaf moron who can't hear good.
Thank you for the tips!
I wish that finger snap -technique would work every time... 😂
nice to see the MR2 back on the channel, stoked for whatever the future holds for it 👍
Hopefully lower it a bit, get some spicy wheels, and drive it like I stole it!
W video
great vid, yall deserve way more followers!
cool
looks like mine
hey i just got my sw20, i noticed that you have a aftermarket steering wheel, does your horn work? i was looking to get it to, but is a little sketch to remove/cut cables
any tips?
thanks! :D
btw love your sideskirts
My horn did work until Installed the quick release. It’s not too sketchy, I say give it a shot!
Was it the Hub or bearing???
Not sure yet, next video it’s gettin taken apart. Hopefully just the bearing
comment
👀