How to make a Ford Ranger look AWESOME | 2.5" Leveling kit install + wheels & tires
Вставка
- Опубліковано 5 вер 2024
- Freddy shows you how to install a Rough Country 2.5" leveling kit on a 2019-2022 Ford Ranger, paired with some wheels and tires it totally transforms the look of the Ranger.
Get the leveling kit installed in this video here: amzn.to/37bpmrf
PMM store:
► www.amazon.com...
Tools that you NEED
►AWESOME Screw Drivers: amzn.to/2XnZuDv
►Amazing Electric Ratchet! amzn.to/3kb90mm
►POWER PROBE amzn.to/3lqoi6c
►OBD2 scanner amzn.to/2JLRCkE
►Welder: amzn.to/39dbM42
Automotive Products I HIGH recommend
►Turtle Wax Seal n Shine: amzn.to/32AEPtL
►194 LEDs amzn.to/2xXxNBu
► Dash Cam amzn.to/2JTrvIs
► / pmmods
► / poormanmods
Finally someone who really know how tonuse all the tools. Thank you mate!
Haha you're welcome 😆
Excellent Video. Thank you!
Make sure you get a front end alignment immediately when finished. If not it will destroy your tires.
Hello, my 2020 lariat cv came out...shitting myself 4 an hour, but grab the rotor and push hard while wiggling went in perfect!
Awesome tutorial, did it effect the drive shaft angles at all just curios. I had a issue where ford had a tsb where I had to get my drive shaft, pinion angle shimmed to alleviate the vibration. Thanks for the video, looks amazing
Rough Country wooo. You did a better job than I did with my Tacoma 😂
😂😂 thanks buddy
Why not loosen LCA bolts and let the LCA swing down further to not have to press in/out the shock bolts? I assume an alignment is needed anyways. Press out the stock lower shock bolts and replace them with a similar hex head bolt you can easily slide in/out?
I think the way the control would move in an arch it wouldnt be easy getting those bolts to go into the control arm. But you could try that
What's the offset on those wheels?
What size tires did you have again? I’m trying to upgrade my stock Hankook Dynapro ATM
What was the offset of these wheels? i want a fit close to flush with the fender. Not too wide where i would need fender flares
+25 same I have on my Ranger
Hahahaha that intro.
Hahahah
Hey! Where are you guys located. Can you guys install it on my ranger?
how much do you charge for installation, my Ranger is 2019 2wd
Definitely remove the axle nut and sway bar end links and you won’t over extend the C.V axle and shouldn’t have to remove the lower studs on the strut to get them in with the spacer.
side note I don’t like the ride of the Ranger FX4’s (I went with a 21 Tremor) part of the issue is the OE FX4 dampers but it’s mostly that ultra stiff rear mono leaf I know it’s subjective but with the RC leveling kit ride probably just got worse IMO (looks good though for very little $) I probably would have went with the Fox 2.0 or 2.5 kit or something similar from king etc. It’ll definitely cost more than just the spacer kit but you get what you pay for 🤙
Thanks for your input!!
I also have a 21 Tremor, did you install a levelling kit? If so which one did you get?
Why do automakers make the front end lower. A whole 2.5 inches lower in the front that’s a lot. So dumb. Looks amazing with the Leveling kit and I love those rims and tires.
They do it so it's level when you put a load in the bed or hook up a trailer
Hey poor man, would you by chance have any info on tuning QR25DE engines? Just found your balance shaft removal vid for the SE-R Sentra. I own an 05 Altima with the same engine and a decent list of performance modifications.
I had a performance shop tune mine with UpRev when I turbocharged it
@@PoorManMods I’ve been stuck between uprev and bully dog but everything is pointing towards uprev so I’ll look into that thank you man. Another thing, is the car still good with just cutting the chain and leaving the balance shafts and stuff in there?
Now they're going to hire you again just to fire you
Hahahahah 🤣
Why don't you show how to lower the truck i am an older and short person
Just get a Maverick if you struggle to get in a mid-sized truck.
13 mins... my guy better not say 4 hours lol, anyhow what was the actual time for install
I lifted my truck but my phallus is still smaller than the lift kit. This is absolute bs.
Whaaat
Buy pre 1990 and that's all that's required
What?
Not worth lifting if you ain't going 6+ higher
What?