Preventing Ford 9 Inch Rear End Leaks!
Вставка
- Опубліковано 3 сер 2023
- In this video i show how to prevent and solve all of your ford rearend axle leaks and pumpkin housing leaks forever! I also show how to install axles on a ford 9 inch.
This is what i used in the video (Permatex Ultra Grey):
www.amazon.com/Permatex-82195...
Watch the full video of this 9 inch install:
• Ford 9 Inch Rearend In...
Check my other videos on my channel and subscribe:
How to fix valvecover leaks for good:
• How To Fix Valve Cover...
How to wire LED headlights on a camaro / firebird:
• How To Wire LED Headli...
How to fix a broken emergency brake cable on a fifthgen camaro:
• How To Fix a Broken Em...
How to replace spark plugs on an impala:
• How To Replace Spark P...
Will it run and drive after 45 years? Barn find:
• How To Properly Resurr...
How to Replace Wheel Studs
• How to Replace wheel L...
How to Make Steel Braided Lines:
ua-cam.com/users/edit?video_id...
How to install a holley stealth ram:
• How To Install a Holle...
How to repair stripped threads using a helicoil insert:
• How To Repair Stripped...
How to convert from a mechanical fan to electric fan:
• Mechanical Fan To Elec...
How to install a 4L60E into an older car:
• How To Convert a Stick...
Klowny1969 thirdgen second generation camaro firebird chevelle nova corvette trans am chevy chevrolet honda lexus nissan ford mercury Mitsubishi corvette Saturn kia tesla lokar emergency brake cable install - Авто та транспорт
looking underneath i was like man this is a well maintained car and then mr clowney said this is my car , makes perfect sense.
Lol thanks!
Nice fix! Well done!
Thank u sir!
@@klowny1969 personally I like the shocker installation method. I use it on your sister...
Another great video
Thank you
Ughhh! i just replaced my seal on a 63 thunderbird and it leaks worse than before. i guess i'm doing it again with ultra grey. This shouldn't be necessary. I think it had the original seal in it or it had a very old one made out of some heavier gauge steel than these flimsy aftermarket ones.
Yep..ultra grey should work great! Thanks for watching and don't forget to subscribe 😉
@@klowny1969 It worked, hasn't leaked after several long drives.
this mercury is a beast
Thank you
Why don't you use the axle flange gasket?
is that even necessary with a sealed bearing?
@@mooosestang I don't know. They offer them for a reason so I would guess so. If you have bad venting or overfill your 3rd member sometimes that shit will spray out the axles when shit gets hot - so I know there is a way for some gear oil to get passed it.
What part of NY are you located?
Long island
I use Optimum Grey (AKA Max Torque and High Temperature), its stronger then the Ultra.
Thanks for the tip..don't forget to subscribe 😉
Need a video called “Preventing SBC oil leaks”….👍 (and dont say “Get a Ford!” all you wanna be comedians out there! 🥱)
Lol I have one for sbc valvecovers
@@klowny1969 i used it. My valve covers dont leak. My oil pan and RMS tho….well….😑