Hey, if i disable CAN sensors how and were can i use universal senors like BEA Eagle2. I use power from terminal 5 witch is +24V and twrminal 7 for 0V. Were ill find start for opening door terminal 4 witch is AuxIN with ? But how do i activate AuxIN?
Did you pull out the block after 9 flashes? 9 pulses Back to factory settings (afterwards emergency stop must be actuated within 10 seconds) This will reset any settings changed
Hello Tecman 67 Thanks for the video. However, when we reset the unit, while the operator started working, the maintenance message continues to be there. I believe that after 13 days, the operator will stop operating again displaying the same message. Can you please advise how to permanently remove the message. I understand that in order to avoid the alert, the target has to be set to 0. Where and how the target can be set to 0? Your explanation on this will be very useful.
The operator will NOT stop working. This is just like a service light on you vehicle. The default setting is 60wks. You should have a safety check at least once every 52 weeks.
@@shakzahmed1 One of the side sensors is causing this issue. Check for adjustment, objects too close or possible fault with sensor. If this is not within your skills, I recommended to call an accredited automatic door engineer
Thanks for your video.
The manual was not helping 🤗👍
I have error BAT CAPACITY 😢 it’s a Sunday and it’s freezing .. so I require my doors on automatic .. do I need to call out an engineer?
Hey, if i disable CAN sensors how and were can i use universal senors like BEA Eagle2.
I use power from terminal 5 witch is +24V and twrminal 7 for 0V.
Were ill find start for opening door terminal 4 witch is AuxIN with ?
But how do i activate AuxIN?
How can i change the language? I tried 9 blinks but its not working.
Did you pull out the block after 9 flashes?
9 pulses
Back to factory settings (afterwards emergency stop must be actuated within 10 seconds)
This will reset any settings changed
merci
Hello Tecman 67
Thanks for the video. However, when we reset the unit, while the operator started working, the maintenance message continues to be there. I believe that after 13 days, the operator will stop operating again displaying the same message.
Can you please advise how to permanently remove the message. I understand that in order to avoid the alert, the target has to be set to 0. Where and how the target can be set to 0?
Your explanation on this will be very useful.
The operator will NOT stop working. This is just like a service light on you vehicle. The default setting is 60wks. You should have a safety check at least once every 52 weeks.
@@tonypoch thanks 👍
Hi sir i want to know about assa abloy sl500
Hi plz i want manuel programmation for manusa bravo
🙏🙏🙏
How do I solve kollison 63 please?
Pls how can i clear code 97 ( maintenance time exceeded)
It is explained on this video at 0:45
@@tecman6724how do i fix code 47 SIO 60s active. Because door keeps opening slowly
@@shakzahmed1 One of the side sensors is causing this issue. Check for adjustment, objects too close or possible fault with sensor. If this is not within your skills, I recommended to call an accredited automatic door engineer
@@tecman6724 im new tryna get my head round it but nothing is blocking it.
Dimana bisa mendapatkan barang ini record stm 20
How to solve the problem "No running parameter and calibration run?"
follow my other video to calibrate the door ua-cam.com/video/o3cMGaJNf0k/v-deo.html
thank for you help..
glad it helped