It's sad I mentioned to Atomstack about this concept calling it a Convergence laser then make it can call it a Compression laser. It showed up about a month or 2 after I mentioned the idea.
Where did you focus the laser on the cuts. Looks like it was focues to the surface as the bottom of the cuts are pretty charred. On thick cuts like this, does the laser and protective cover allow enough room for a center focus?
Zdar, neskusal si 3mm alebo 4mm topol preglejku? Zaujimala by ma max rychlost mm/min na 1pass. Tento laser mam objednany od 6.12. a stale nic neprislo tak som zvedavy aky velky upgrade to bude oproti OLM3. Dik!
What parameter to cut 3mm plywood ? Thanks
It comes with a rotory for doing tumblers, etc but where are the leg extentions to raise the frame?
It's sad I mentioned to Atomstack about this concept calling it a Convergence laser then make it can call it a Compression laser. It showed up about a month or 2 after I mentioned the idea.
Where did you focus the laser on the cuts. Looks like it was focues to the surface as the bottom of the cuts are pretty charred. On thick cuts like this, does the laser and protective cover allow enough room for a center focus?
Amazing, link to purchase, please
How well does it cut 3mm MDF? I'd be keen to see a power scale chart for it.
I don't have MDF , I cut HDF board 3mm speed 600mm/min (10mm/s),
@@kukomio Awesome, thanks!
@@kukomio have you tried 3mm birch plywood?
Zdar, neskusal si 3mm alebo 4mm topol preglejku? Zaujimala by ma max rychlost mm/min na 1pass. Tento laser mam objednany od 6.12. a stale nic neprislo tak som zvedavy aky velky upgrade to bude oproti OLM3. Dik!
Multi-pass is better