One of the best value kits for your Defender you can fit in under an hour.

If you've got a rubber mat or carpet in the back of your Defender, this kit will make a huge difference in keeping the noise and weather out. Fot just £27 (+VAT) you get a brand new rear door seal, stanless steel threshold and a lower door seal rubber - something that every 90 and 110 should have. It takes less than an hour to fit and is the perfect upgrade to fit this weekend.
Buy the parts used in this episode here:
LRC1371 - DEFENDER SAFARI REAR DOOR SEAL AND STAINLESS STEEL RETAINER KIT - FITS FROM 1983 TO 2016 LAND ROVER DEFENDERS
www.lrparts.net/lrc1371-defen...
JWP1205 - TOP MOUNT REAR TAILGATE DOOR GAS STRUT STAY KIT FOR LAND ROVER DEFENDER 1983-2016
www.lrparts.net/jwp1205-top-m...
Chapters:
0:00 Intro
0:18 Whats in the kit LRC1371
02:18 Fitting the rear door seal
04:37 Instslling the lower seal and stainless steel threshold
06:27 Checking the fitment

[@453421abcdefg12345]

I found the really good thing about this threshold kit is that the holes in the stainless plate are punched just slightly out of line with the original fixings, this means that it is simple to position the new trim, then drill new 3 mm holes for the self tappers, and it makes the entrance look really smart, the best £30 you can spend! Chris B.

[@markriley2733]

Always reassuring to have your back door securely sealed 😂

[@453421abcdefg12345]

This is the best addition yet! Nothing is worst than opening the door and seeing the dull corroded rear door trim with rusty screws, I will order this right away! If I can drag the back door closer damper out of it's closed position! Chris B.

[@jonnysnakes5417]

That will be on the to do list
Along with new a strip for the drivers door

[@grahames9228]

Good one.

[@stuartdenty3163]

Nice one Fraser, thank you

[@LRLiveUK]

Very welcome

[@ChristianBorrman]

use screw removers to remove the old screws rather than grinding head off, otherwise the rotting old screw is left in

[@ChristianBorrman]

done bought! did you manage to drill
out old screws using the plate template holes? lucky

[@LRLiveUK]

Yeah, They drilled out fine so might have been slightly offset.