Cat 320DL EXCAVATOR LOW POWER & OVERLOAD, HOW TO FIX.
Вставка
- Опубліковано 22 жов 2021
- this video we will show on how to repair and adjust the main reason of overload and cause of low power, through flow pump adjustment. keep on watching and learn.
disclaimer, i will not advice to anyone to do this type of work if you do not know or understand about the process and procedure.
Really hard to find any info on diagnosing excavator problems sure glad you did this one. Thank you.
Thank you master.. for help us by this informative video thank you so much
Hae sir .you helped me to fix the problem. Thank you very much for your video.
To be honest your very helpful, thankyou
again great video
Nice shot MASTER. This adjustment must done in both pump, i mean right and left side, the same size of turn, counterclockwise, until the engine not dying when u move the joystick. First make SURE power shift and main relief valve pressure are in spec. Important also to know about whats first and second stage.
Nice work
Please show point, where connected pressure gauge?
Thank you boss
👍👍👍
Mi pluma perdio fuerza al escarbar alguna solucion ayuda gracias
sir jun we have also here in davao city philippines a Cat 320d, engine RPM will not increase or go high when we operate the unit,your advice to this kind of problem is highly appreciated,thankyou and more power to you po!!
تحياتي سيدي بارك لك الله في عملك واعانك سوءال هو اين اجد صمام تحكم في قوة زيت مطرق هيدرولكي على موزع هيدروليك وشكرا محمد من مملكة المغربية
شكرلك اشتلد اين المشكله في هذه الحفار
I have been having this problem with my 1995 ex60-3, and thought it was a fuel issue I will get some help to establish if it is pump problem, thank you.
good night smigo...I have a problem with a caterpillar 312A that does not indicate engine temperature, hydraulic oil temperature or fuel level on the panel monitor. It started with a fault that the power was not going to the monitor, the machine stopped accelerating due to the knob acceleration now only does it manually the governor was replaced but it does not allow me to calibrate it reaches ACP01 and stops I would appreciate if you could guide me in a solution thanks in advance
sorry I looked at the manual i was wrong HIGH5. good work my bad
my friend I have one question why the out put flow of the pump changed , when the same hydraulic pump is working good before
I have a crank but no start can you help me and I also have the codes that was registered in the cat computer
لدي مشكله في كتر بلر.320dL ينطفي المحرك من حاله ماهي المشكله انا اخوك سالم من اليمن