I am having the same problem in Remington hair curler. It's not heating up. According to your advice, I will change the microcontroller resistance. I'll also let you know later on. Let's see, what happens.
I'm not sure how you can change the microcontroller resistance but whatever you do, be careful. The device in question in my case is called s thyristor. It had nothing to do with the microcontroller as it was working OK.
@@TasteTheCode I wrote that because I've got one that doesn't beep but shows a value (1890) on continuity testing but nothing when I put the multimeter on 2000 Ohms setting. So not being a specialist, I'm a bit puzzled.
That's too bad. Check with any of your friends. Someone might be into electronics and can try to diagnose what is wrong with it. Last option is to take it to a repair shop.
I am having the same problem in Remington hair curler. It's not heating up. According to your advice, I will change the microcontroller resistance. I'll also let you know later on. Let's see, what happens.
I'm not sure how you can change the microcontroller resistance but whatever you do, be careful. The device in question in my case is called s thyristor. It had nothing to do with the microcontroller as it was working OK.
Wish you had shown how to test the thyristor...
It usually fails either all contacts open circuit or dead short. Otherwise it has like diode bridge in between.
@@TasteTheCode I wrote that because I've got one that doesn't beep but shows a value (1890) on continuity testing but nothing when I put the multimeter on 2000 Ohms setting. So not being a specialist, I'm a bit puzzled.
What's is the zener value beside 10 v 100mf
Sorry, I can't measure it as I no longer have the iron. I gave it back once I repaired it.
Hello Sir Ikonic crimper machine Eror shows please tell me what fault
No idea, I don't own that device.
Very clearly explained, thank you
You're welcome!
which micro controller is used to control the temperature
No idea. You can't see it on the video but there is a resin blob under the screen that covers the chip.
@@TasteTheCode ok thanks
My curling iron also stopped heating....but i dont have the tools and knowledge to repair the way you shown 😫
That's too bad. Check with any of your friends. Someone might be into electronics and can try to diagnose what is wrong with it. Last option is to take it to a repair shop.
I want vega vhch-04 R2 resister value
Sorry, I no longer have this to check the value.
Bro can you give me circuit daigram of this with value
Sorry but I do not have it. What is wrong with it?
Good tiching 👍👌👍👌👍👌👍👌👍
Many many thanks 👍👍👍
I need its diagram
Sorry but I can't help.
Mine is a wire that is not funcioning
Functioning*
That is a typical resistive heating element. Please be careful with it as the mains voltage runs through it.