ok thanks, mine wont come out of limp mode even with doing the reset procedure several times and I'm thinking that switch itself might be bad, thanks for the quick response
I don't but here is a good write up with pictures. www.mudinmyblood.net/forum/66-snorkeling-jetting/2609-how-snorkel-prairie-360-a.html#/topics/2609?page=3
I have a grand prairie and i want to install a little lift kit like yours on the back can i put a stiffer shock cause i hate when ppl get on and it lowers alllll the way down also do u have a vid on how to install the lift kit
Yes you should be able to replace the spring with a stiffer spring, but added with the lift you will put a lot more stress on the u-joint on the drive shaft going to the rear diff. I don't have a video, if you had a cherry picker(engine host), unbolt bottom shock bolt, lift rear of atv up, then bolt lift kit in, do the same on the front, besides I think I had to use a small ratchet strap to compress shock to fit it back together with lift.
@@jesse6265 On the bottom of the shock there is the adjustment, there is a tool for it, or a big pipe wrench works also, right were the spring meets the adjuster, there are usually 3-6 positions.
@@joshjorstad6677 btw do u know how to install the 2 inch lift kit in from of grand prairie 360 i cant find vids and in having a hardtime knowing how in front
ok thanks, mine wont come out of limp mode even with doing the reset procedure several times and I'm thinking that switch itself might be bad, thanks for the quick response
do you have a vid on how to snorkel I have the same atv and want to snorkel but cant find any good vids on this atv.
I don't but here is a good write up with pictures.
www.mudinmyblood.net/forum/66-snorkeling-jetting/2609-how-snorkel-prairie-360-a.html#/topics/2609?page=3
nice vid mate, where did you get your 02 temp sensor from ? any info on wiring it ? thanks.
so to bypass the bad belt switch you just wired the two wires going to it together and that worked fine ?
yup that is correct. then later took cover off and just broke the hole thing off and sealed the small hole up with RTV sealant.
I have a grand prairie and i want to install a little lift kit like yours on the back can i put a stiffer shock cause i hate when ppl get on and it lowers alllll the way down also do u have a vid on how to install the lift kit
Yes you should be able to replace the spring with a stiffer spring, but added with the lift you will put a lot more stress on the u-joint on the drive shaft going to the rear diff. I don't have a video, if you had a cherry picker(engine host), unbolt bottom shock bolt, lift rear of atv up, then bolt lift kit in, do the same on the front, besides I think I had to use a small ratchet strap to compress shock to fit it back together with lift.
@@jjorstad18 on the shocks how do i put the level on all the way up
@@jesse6265 On the bottom of the shock there is the adjustment, there is a tool for it, or a big pipe wrench works also, right were the spring meets the adjuster, there are usually 3-6 positions.
@@joshjorstad6677 oh ok found it thanks alot guys
@@joshjorstad6677 btw do u know how to install the 2 inch lift kit in from of grand prairie 360 i cant find vids and in having a hardtime knowing how in front