DSO138 FIRMWARE UPDATE USING CH341A MINI PROGRAMMER

[@antikasoundengineering4222]

Insya ALLOH sangat bermanfaat saudaraku. Tank's

[@ZalStudioDiy]

Alhamdulillah.

[@reza6x]

So much thank you. You are awesome❤

[@ZalStudioDiy]

Glad you like it.

[@nasifkhan5]

Thanks 🎉

[@ZalStudioDiy]

You're welcome.

[@kawuloalit3504]

bang cara resetny gmn y pny q g mau reset pas minta reset

[@ZalStudioDiy]

Alamak sorry sebab dh lama tak sentuh device ni. Mmg dh tak ingat cara reset dia.

[@techman6431]

It’s important to update firmware or no

[@ZalStudioDiy]

If the one you have works just fine for you, then the answer is no brother.

[@mm-lw3lo]

DSO138 прибор новий,пропав промінь,пробую прошивати програтором CH341A MINI PROGRAMMER та USB TO TTL видає програма помилку -No response from the target the Boot loader can not be started.Please verify the boot mode configuration and flash protection status.Reset your device then try again... - конфігурацію RX-TX міняв. Що може бути ? Дякую за відповідь!
DSO138 is a new device, the beam has disappeared, I try to flash it with the CH341A MINI PROGRAMMER and USB TO TTL programmer, the program gives an error -No response from the target the Boot loader can not be started. Please verify the boot mode configuration and flash protection status. Reset your device then try again... - I changed the RX-TX configuration. What can be? Thanks for the answer!
I did everything according to the instructions and put the jumpers.

[@ZalStudioDiy]

I really have no clue. Sorry.