Some suggestions and recommendations. You don't have to grease the pinion and spur. Grease is only needed on metal to metal gears. Another good motor replacement for this would be the Dynamite 20T or 15T brushed motor. They are very similar to the silver cans you get with Tamiya kits.
Thank you for the advice, always appreciate it! I’m actually having issues with it running so idk if the motor is bad or it might be the pinion because the mesh seems a bit tight
Nice vid! What is the pitch of the pinion gear you used if you don't me asking? Doing a 2260kv in my DEERC 210e and need pitch to buy the new 23t pinion.
Still can’t wait until you pull out the Sleek 😂
I almost did lol
Some suggestions and recommendations. You don't have to grease the pinion and spur. Grease is only needed on metal to metal gears. Another good motor replacement for this would be the Dynamite 20T or 15T brushed motor. They are very similar to the silver cans you get with Tamiya kits.
Thank you for the advice, always appreciate it! I’m actually having issues with it running so idk if the motor is bad or it might be the pinion because the mesh seems a bit tight
@@BargainBashersRc Your welcome. Try using a pinion with one less tooth. If the pinion is a 25 try a 24.
@@alphawlff good idea, I’ll have to see what pinions I have
@@BargainBashersRcpretty sure the issue your having with that motor is because from my research it only works with NOS.
@@PokeThrillz must be
Nice vid! What is the pitch of the pinion gear you used if you don't me asking? Doing a 2260kv in my DEERC 210e and need pitch to buy the new 23t pinion.
Thank you, it was a 48 pitch. I think there is a link to the one I purchased in the video description if that helps you
@@BargainBashersRc appreciate that man, didn't see in the vid or comments! Now to find a 23t for a 5mm shaft! Pretty sure I follow you on FB also👍
@@ofromda860 thank you!!