Mercedes Benz 2009 C300 Front SAM Unit Replacement And Repair Dont Forget To Do this wiring part1
Вставка
- Опубліковано 7 вер 2024
- If you need parts or accessories for your Mercedes Benz click the link below:
Mercedes Repair Info
www.startekinf...
Mercedes Parts
amzn.to/3S0Z11y
Mercedes Accessories
amzn.to/3HDdFY6
Appreciate the video. Some technicians I have talked to said it was pretty obvious that there was an additional PIN on the new F-SAM's. Others said it wasn't obvious. This video helped a lot thank you.
Thank you very much Muhammad. I was going coo coo over this, the vehicle cranked 🎉😊
Excellent video. very informative. can you tell me if this will also work on a 2011? I noticed that the #4 pin is used in the white plug in my car.
Thank you so much for the update
How do you remove the big red cables? im having a hard time trying to remove them
Thank you I also will need to try this but also my cluster isn't working unless I take a fuse out and place it back in or only if I unplug the ignition switch then replug it back up with the key already turn to the on position btw 2010 c300
Nice technical video lecture. We can understand
I need this part of mercedes benz viano CDI engine.
Having same problem with my 2011 no wipers , turn signals , reverse lights etc pretty sure its the sam module because water got in that hole where the module is located and having the same issues
yes its my brother
I need to get that piece ,I purchased my esl and ignition switches reprogrammed finna go buy a new starter too but I think I need to try this first
let me know if you need help
This pypass wire will work on the piracy program, and it will affect the auto light and you’ll have error messages on the dash.
Thanks man you just save my life.
Glad to hear that
Your video is excellent
Please l have the same problem.
I have. SAM A2045446301 I replace with A2045455501
everything works except the window not working.
Please advice
Where do you buy this adaptor
The front sam it has to be new or used one?
Hello Mohammad, your video is very helpful and your way of explaining is very easy and great. We got a situation that no one knows how to fix it. We got a 2010 Mercedes E550 Coupe and it had a bad 12 Volt battery, our fault is that we replaced the battery while the car was running! after turning off the vehicle it doesn't want to start again. there is electricity now but no start. There is couple codes showing:
Code#42A400Control unit N30/7 Electronic stability program premium control unit has detected an under voltage. The second code#428300 Shutoff due to under voltage. Can you Please HELP us ? It is doing the same as your car here.
Hello
Good evening
BIG! THANKS!!
You welcome
How does water get into the SAM? Are they not protected by a waterproof cover?
Usually a build up of leaves and stuff in the drain clogs it up and forces water inside the SAM.
Typical Mercedes being cheap I feel like.
I'm Auto Electrician i the same problem this evening
Hello my friend, thank you for this information. I changed the panel, and there was a problem with the windows and side mirrors. They work in the opposite direction in the buttons. Does this method work for this problem? Thank you, brother Muhammad
I have a 2009 Mercedes Benz c300 sport 4D. Anyone know of a video on how to install the sun visors? No matter what I’ve tried the clips won’t go into place. Any help would be great thanks.
I appreciate your video. I have same problems. I’m removing the box but the two red wire on both sides are not coming out easily. Any tips on that? I am squeezing on the side but no luck
it happen to me also just see in side you will see a clips
Any luck did that fix your no start??
did you manage to remove them ? im also having trouble
I bought two Sam from eBay. But they both got corrosion on them. I’ll have to order new from dealer.
Yes I press with the screw driver on the side instead of with my finger and pull at the same time and it works
really thanks a lot
I was wanting to ask you question what is a 1078 code on my code reader it said it was the purge flow of the evaporative emission control system is too low but when I look on line it says it's a intake vavle flap stuck
How did you get it out without removing wiper motors and plastic?
What if pin number four on the white connector is already occupied but pin 12 isn't
Mines is just like yours what do I do
What is the purpose of wire?. please educate me
Is this not called central gate way ?
I need to replace the sam unit on my mercedes 2010 c300 you know where i can reprogram the sam replacement?
I need help to locate hood sensor wire in Sam module c class w204
How do you update it. I just got this done in my car and now the seats don’t move, the passenger mirror won’t go down when I park and the led lights are not working. I paid 1700.00 for this job and these things were all working prior to the car shutting down on me. My car is a 2011 c300 4 matic sport .
Is it a different Sam module for a 2008 c350 they look the same
You are awesome 😎 and thank you 🙏 🔥🔥🙏
Thank you too!
What if my number 4 slot is taken?
thanks you, I need some advice. the old sront sam for a204 got damaged by water, bought another one but its like we made a mistake of buying an automatic sront sam from a manual car. Is there any possible was to change it to work for the manual car?
not that i know
Just rained heavily yesterday and my siren went off and my lights or windshield wiper wouldn’t work I’m thinking rain got into my front Sam. Everything seems to be working today but I don’t want to risk the chance of it happening again should I replace?
clean the sun roof drainer first please
Thanks for the video, pls I have a question if you don't mind? pls how will one know if an Air condition climate control system of Benz 2008 C300 is faulty?
the climate control module is to give you the function you want from a/c to heat and so on if the something is not working you have to check the component first then and also the command of the module at the end you need a good scanner to check the system
@@BestCarFixes thanks mate, I appreciate 👍
Hello! Pls what do you mean by upgrade? Are you saying the part number is different on either sam?
I did not check the part number but when you buy the sam module and program it the the starter will not crank unless you connect the 2 pins
Doing today I'm having problems with my lights on my 2008 Mercedes-Benz C300 my lights won't quit flickering on and off my dash lights my security lights don't flash no more when I turn lock the doors on my car brake lights won't quit flickering headlights dash lights on my lights I don't know where it is people tell me if the ground I don't know what to do can you please please help me
i have a 2010 glk350 4matic. i short circuited my left fog light after installing an aftermarket LED bulb in the wrong positive/negative ports.
do i have to replace the whole SAM? or is their another method?
If the short is in side the sam you have to repair the sam or change it
@@BestCarFixes any suggestions on how to repair the SAM without replacing it? also, can i hook up the fog light that isnt working to the one that is working?
Hey my 20007 c280 won’t crank no power, could you direct me. Seems it’s the circuit 30
is ignition on ? if so see on the data is the crank command is received in the engine computer data
I need help figuring out we’re my relay is to my blower motor
this car doesn't have blower a motors relay its together with blower resister
What do I use to program it? What scanner?
hello i have 211 2008 it wont start i check fuse 43 n o power to the ecu
and for the front sam there is 12 v power
can you help me please
is the key turn on and of dash is on or not
Security accounting management pin where the secret pin numbers are stored
Hey , i have my car not startet . I changed the Sam . Startet 1 week and out . No communication . Mercedes c280 v6 , 231 ps .
Thank you
check the can system and see what make it like that 13472281875
Thanks for this. I am having a problem with this right now. I need a part but the dealer want $700+. Any suggestions on where I can get it from thats less expensive?
in some car the used one will work look at eBay and see if you can get something from the same year and model i should work
what year is your ca?
2010 c300
I have a 08 c300 it needs a front sam Can i use any sam module of this year and model regardless of the part#?
No you mut go by part number that is on the sam module
@@BestCarFixes (i bought a non running one) mine came without one its missing , and idk what module to buy, how can i know?
Dealer dont sell them any more
My friend has a 2010 mercedes e350. High beams not working side marker light not working both sides. Fuse and bulbs and wires are good. If i put a new sam module and use this wire will the car start ? Do i need to program anything else? And also does this blue jumper wire stays there for ever? Thanks
this is only for new module if you get used one same year not programmed not recently putted in the car it will work
@@BestCarFixes so basically just plug and play without program or scan tool?
yes if its used one
i did one for 2009 and it work
most of the time yes
I think I need a new front sam but not sure no crank no communication and my fans runs on high speed does that happen with the can bus too(the high fan)? Or only the sam?
Be sure
@@BestCarFixes thanks for the reply, do you know if the can bus will cause the fan to run on high as well ?
Did you get the answer. I’m with the same problem.
Hey man can you please tell me something about hood open warning i have changed the sensor too but my car is still beeping while driving showing same problem your hood is open but it is closed . Is there any fuse or something else to do with this ?? Please tell me
in some Mercedes-Benz if you change the front sam module you must code it and program it if not it will show you that the hood is open
Hi, how did you fixed it? I have same issues at w204 2008
Thanks
Where in nyc are located ? & how much you charge to fix this problem?
Hello i am from hungary, i have a same problem i think the sam i have a video from the car how to send it to you ?
Send it to my whatsupp account +3472281875
What size star bit fits the fuse box removal
I'm not sure
T20
Hi again .
If I buy SAM from same year but the numbers are a little different, could it still work or do I have to program it
You have to check the compartapilty. By dealer
First...great video 👍. My problem is my 2010 GLK350 will not communicate with my scanner. So, I was wondering if I installed this wire will it make it communicate with my scanner. I bought this suv used and it does not have a wire to the terminals you are talking about.
Thanks
I cleaned it well and finally I’m able to turn it on . Thanks for your videos! I still have codes but at least is it drives
@@playbig22any luck on finding if this allowed your scanner to work?
Hello
Hey why you not cranking a car after connected
Top
How do you stop water from getting into front Sam
clean all the drainers
or you can add a plastic shield cover .. i was thinking that . just cut some thin plastic sheet .. use zip ties .
The AC light won't come on, why won't the car start? Mercy C200 if the AC light is on, the car will also start
Same problem
It's the same as the problem with what you have been working with
How do we remove the SAM module cover please and thanks😅
what year and module ? some of them has 2 clips toward the strut tower mount
Lol I know there difficult I hate these cars 😅 just remove the front clips on the left and pull hard
السلام عليكم اخي
عندي مرسيدس c280 v6 صار لديها مشكله ماتشتغل غيرت الSam اشتغلت فتره اسبوعين ورجعت فصلت كل مره اغير الsam تشتغل وتفصل ف اذا عندك رقم استطيع التواصل معك . وشو الحل برايك نفس ماسويت انت اوصل كابل بين ١٢ و٤
1`3472281875
الرجاء رقم تلفون كامل مع رمز البلد كي استطيع التحدث معكم جزاك الله كل خير
Pin 4 has something in it already
What MB and where does the other end of the wire terminate?
Let know the old Sam module faults before you change to the new one
Ok
Which one is the part number??
A 204 440 37 13
So dear sir pin 4 is blank
U replaced the adapter,but u didn’t start the car to verify if the car actually started 👎🏾
after seeing this guy work i trust him . .it started .. hahahaa
Where are you located
Brooklyn ny
@@BestCarFixes Im in florida im having the same issues with my 2010 c300 it started not tuning on one day and i had water underneath the floor like up to the wires on both sides
So many problems with Mercedes front SAM module and water, such a bad design
yes
@@BestCarFixes currently have a 08 c300 with an out driver side low beam. Put new bulbs in on both sides and now the passanger side doesnt work but drivers does. Do you think it is a SAM issue?
This video is not informative.
Thanks for sharing
My pleasure
What if my number 4 slot is taken?