Ooo yes, so the brake acts through the Valve control Oil Distribuitor from your cockpit, meaning that when the Control Handle is in the Middle position the hidraulic motor cannot turn Right/Left? anyway, Great Job! do you have more pictures with the assembly? (a web page that I can follow)
Yes, with the over-run valve you send 300psi to pay rope out. If there is a tiny leak in the motor the drum creeps out under full load. (Mine does and always has)
I would use to plow snow electric winch. It is cheaper, simpler to install. I do not need a second battery, just that the engine will be walking and you will be watching the voltmeter. Hydraulic Winch is only for extreme applications.
@SebastianTJ Tez robie hydraulika u siebie i mam mały problem z pompą....bo u Ciebie widać, ze jest mała, kompaktowa. A wszytski ktore ja znajduje co mają 60l/min mają rozmiary skrzynki po butach :) Mam fajną, małą pompe PZ20 - 160bar ale tylko 20l.min. Poszukam u producenta co podałeś, dzięki.
If it is meters per minute,, and I'm sure your correct, why does it have a "B" after the "M" as it says 9,5 mb/min.? Also with the metric system why don't they use a decimal rather than a comma? Not being picky just curious.
Do you think I can run that from the pump for my snowplow?The pump runs off of a belt.I like this better than electric because their is no second battery to carry.Also I do not need to mount a pto. I know the snowplow is very heavy, and the ram with no plow on can lift nearly half a ton.
I have a PTO mounted 5000 PSI pump it has a diverter valve that separates Plow piston from Winch and Char-lynn pump. I put a 12 volt solenoid operated valve to change directions of the flow. The plow system will pick up the front of my F-350 and the winch is set to almost break my 3/8 cable with a pressure regulated line. I had this system on a fan belt run pump. It was always slipping. Now it is fast smooth and very controllable.
@jedkerKTM525 I'm not quite sure if you want to know how much can it pull, or how much does it weigh. A heavy Warn winch for a Jeep will weigh 62 Kgs. It can pull 5440 Kgs. There are heavier winches, and there are lighter as well.
I do not remember exactly, but it's a simple gear pump. nominally 160 bar 60 l / min. mounted in place of the air-conditioning compressor, with an electromagnetic clutch with a latch. P. S. I have the whole set for sale, it's like new, with the winch, hose, tank, pump, control
@Arni121986 Pompa produkcji WPH.pl nie pamietam symbolu, jest to pompa zębata , wydajnośc 60 L/min , ciśnienie 160 bar , obroty nominalne 1500/min. Pompe sobie dobrałem pod parametry wyciagarki,
Musisz bardzo lubić ten filmik skoro go oglądałeś co najmniej 5 razy :)
Sebastian TJ - co to za pompa hydrauliczna? Dedykowana do zestawu z wyciągarką czy od wspomagania z jakiegoś innego auta? Znasz jej parametry?
pozdr.
Does the winch speed up at higher revs? or will something break with a higher rev?
If you don't know, do you know where to find out?
Hi! great setup man! Bravo!
I have two questions:
1. the hidromotor is bidirectional?
2. what brake system do you have on the winch?
Thank you
Hi,
1. Yes, left and right rotation
2. Is a simple, if the oil does not flow winch will not turn
Ooo yes, so the brake acts through the Valve control Oil Distribuitor from your cockpit, meaning that when the Control Handle is in the Middle position the hidraulic motor cannot turn Right/Left? anyway, Great Job! do you have more pictures with the assembly? (a web page that I can follow)
Yes, with the over-run valve you send 300psi to pay rope out. If there is a tiny leak in the motor the drum creeps out under full load. (Mine does and always has)
congratulations on 125k views :o)
I would use to plow snow electric winch. It is cheaper, simpler to install.
I do not need a second battery, just that the engine will be walking and you will be watching the voltmeter. Hydraulic Winch is only for extreme applications.
@SebastianTJ Tez robie hydraulika u siebie i mam mały problem z pompą....bo u Ciebie widać, ze jest mała, kompaktowa. A wszytski ktore ja znajduje co mają 60l/min mają rozmiary skrzynki po butach :)
Mam fajną, małą pompe PZ20 - 160bar ale tylko 20l.min. Poszukam u producenta co podałeś, dzięki.
Dobrze zmotane !! :)
If it is meters per minute,, and I'm sure your correct, why does it have a "B" after the "M" as it says 9,5 mb/min.? Also with the metric system why don't they use a decimal rather than a comma? Not being picky just curious.
Pulling force?
@jedkerKTM525 That's nearly the heaviest one they offer for a vehicle such as a Jeep Wrangler.There are a few lighter ones as well.
Do you think I can run that from the pump for my snowplow?The pump runs off of a belt.I like this better than electric because their is no second battery to carry.Also I do not need to mount a pto.
I know the snowplow is very heavy, and the ram with no plow on can lift nearly half a ton.
I have a PTO mounted 5000 PSI pump it has a diverter valve that separates Plow piston from Winch and Char-lynn pump. I put a 12 volt solenoid operated valve to change directions of the flow. The plow system will pick up the front of my F-350 and the winch is set to almost break my 3/8 cable with a pressure regulated line. I had this system on a fan belt run pump. It was always slipping. Now it is fast smooth and very controllable.
@jedkerKTM525 I'm not quite sure if you want to know how much can it pull, or how much does it weigh.
A heavy Warn winch for a Jeep will weigh 62 Kgs.
It can pull 5440 Kgs.
There are heavier winches, and there are lighter as well.
what hydraulic pump did you use and how did you mount it to the engine?
I do not remember exactly, but it's a simple gear pump.
nominally 160 bar 60 l / min.
mounted in place of the air-conditioning compressor, with an electromagnetic clutch with a latch.
P. S. I have the whole set for sale, it's like new, with the winch, hose, tank, pump, control
👍👍👍👍👍👍👍👍👍
@Arni121986 Pompa produkcji WPH.pl nie pamietam symbolu, jest to pompa zębata , wydajnośc 60 L/min , ciśnienie 160 bar , obroty nominalne 1500/min. Pompe sobie dobrałem pod parametry wyciagarki,
The literal translation of mb - current meters
I used a comma and decimal number 9,5 m/min.
if someone does not use comma means that the decimal are 0
if you give a larger pump, winch will be faster
What in the world is a mb/min ???
meters per minute
jep je prava stvar
jaka pompa jaka wydajność?
load is small,
This is a test of speed, not pulling,
hydraulic winch has the same speed at maximum load and no load.
Share the rope finishing convenient tools
Search for Winch Finishing Device
@jedkerKTM525 Sorry, I only speak english.
هههه ياخي وش هالاغاني احسب جوالي علق ....