How can I add PWM converter in my grid ? I have created element of converter in network data but I am not able to find the graphic of converter in toolbox. I am using 2017 version. Could you please help ? I searched online but did not get expected answer.
I followed the steps but I cannot see any plot. I know the calculations are done but not showing. Even I introduced new plots on a simulation where I can see the plots and the ones I included are not showing. Do you have any suggestion? Please
Do i need to import the data to Zero sequence impedance (short circuit voltage uk0 HV-MV...) when simulate the short circuit event? if need, what should i do to import the data?
It depends on your design, and the results that you want to obtain. If you want to simulate a simple short circuit event you don't need to change the zero sequence and other settings, put them on default values.
@@asaproengineering i'm performing a project that I need to compare the influence of short circuit on the grids. One is designed with entire line and another is replaced by a length of cable. So should i need to import the data to Zero sequence impedence? If possible, can you teach me how to calculate the uk0 and SHC uk0r?
I love your videos, I'm always waiting for new videos from your channel.
thank you ☺
Thank you for sharing this material, it is very usefull. Very well explained.
Thanks it helped me a lot
Thanks
Hello I want to know how to create about PV(solar cell) in digsilent. Can you tell me or anything please? sorry for my bad english.
thanx so much
Sir i have one question plz i need ur email
How can i import parameters ( ex. Load) in excel file into a grid in Powerfactory? And when i change parameter in excel file then that grid change too
How can I add PWM converter in my grid ? I have created element of converter in network data but I am not able to find the graphic of converter in toolbox. I am using 2017 version. Could you please help ? I searched online but did not get expected answer.
I followed the steps but I cannot see any plot. I know the calculations are done but not showing. Even I introduced new plots on a simulation where I can see the plots and the ones I included are not showing. Do you have any suggestion? Please
Do i need to import the data to Zero sequence impedance (short circuit voltage uk0 HV-MV...) when simulate the short circuit event? if need, what should i do to import the data?
It depends on your design, and the results that you want to obtain. If you want to simulate a simple short circuit event you don't need to change the zero sequence and other settings, put them on default values.
@@asaproengineering i'm performing a project that I need to compare the influence of short circuit on the grids. One is designed with entire line and another is replaced by a length of cable. So should i need to import the data to Zero sequence impedence? If possible, can you teach me how to calculate the uk0 and SHC uk0r?
Is it posible to export these plots to COMTRADE?
Sir Please Help Me I Need Powerfactor correction diagram by using Digsilent software Please 🙏🙏🙏
how to know the maximum and minimum value of a signal? please tell me
Can I contact you
Thanks Sir for the great sharing,
Can you please share your email?
Thanks