Put the radii on last. I would have developed the initial shade oversize and undersize i.e. slightly large OD and smaller ID. Then apply a cut to get the right size i.e after you have completed the pattern and combined. All of your edges will then be tangent and you should only need to select four edges. Much simpler and less radii in your tree.
selam üstad . eline , emeğine sağlık. bir sorun var ilk wrap denemende karşılaştığın problemi line ile full kapattıktan sonra wraplayabiliyorsun. aynı hatayı ben full kapattıktan sonra da almaya devam ediyorum problem ne olabilir?
Easy but tricky. Thank you.
Keep practising Man, you're excelling.
So nice this lecture sir
Thanks for your comment
This tuto is very nice
Welcome
Harika bir kanal. Bize böyle güzel öğretiler sunduğunuz için teşekkürler ☺️
Şimdi oldu 😁 teşekkür ederim ne demek.
Put the radii on last. I would have developed the initial shade oversize and undersize i.e. slightly large OD and smaller ID. Then apply a cut to get the right size i.e after you have completed the pattern and combined. All of your edges will then be tangent and you should only need to select four edges. Much simpler and less radii in your tree.
Good 😊
Wow 😃😄
Thanks 😊
Very nice!👍🙂
Thanks Waldemar 😇
👍👍👍
😊😉
what do you do if someone ask to make the diameter of inside bracelet to be 62mm? then you boss comes and ask for 68mm?
Then you make inner radius 31 mm instead of 12.5
Maybe also you should increase intensity of instances due to bigger diameter
selam üstad . eline , emeğine sağlık. bir sorun var ilk wrap denemende karşılaştığın problemi line ile full kapattıktan sonra wraplayabiliyorsun. aynı hatayı ben full kapattıktan sonra da almaya devam ediyorum problem ne olabilir?
Ustad kapalı kontürün üzerinde üst uste çizgi falan olabilir. Iki defa aynı çizgi gibi. Aklıma başka bir şey gelmiyor.