Fiat 500 Window Regulator Replacement Part 1

Поділитися
Вставка
  • Опубліковано 11 вер 2024

КОМЕНТАРІ • 14

  • @PROKartGo
    @PROKartGo 6 років тому

    I watched it and i made it! Thx :)

  • @isabellaaddison
    @isabellaaddison 4 роки тому +1

    My 2013 Fiat 500 passenger side window regulator broke. I purchased the Dorman 751-649 regulator and used your video to install it. The installation went pretty easy, but here's my problem. When I roll my window up it doesn't go up evenly like it isn't balanced. I have to adjust it inch by inch and put it back into place so the plastic clip doesn't break. I see your regulator has a small wing that goes under the right corner and mine does not. Do you think that's the issue? What brand did you use?

    • @gsgarage2462
      @gsgarage2462  4 роки тому +1

      I used Dorman as well. Hmmm...this is a tough one. I would try pulling the regulator out again and testing its movement by reconnecting and turning key on and then moving the switch. Assuming it works correctly, I would double check the window movement by hand to see if it's binding somewhere on its track or elsewhere. Hope this helps and good luck.

    • @isabellaaddison
      @isabellaaddison 4 роки тому

      @@gsgarage2462 Hey there! I was able to fix the issue. I did not notice at first but the clip that holds the glass in place on the track had also broke. I was able to get a new piece and fix it

    • @swatsn1per
      @swatsn1per 4 роки тому

      @@isabellaaddison I am experincing this same problem, did you get a picture of the damaged clip? I looked at the clip but it looks fine. Any help will be appreciated. Thanks

  • @rneerpat
    @rneerpat 5 років тому +1

    how do you hold window up while working on changing out regulator

    • @gsgarage2462
      @gsgarage2462  5 років тому

      It will usually wedge itself in the dew sweep and hold there. If not, just get a helper to hold it up while you remove and re-install regulator.

  • @seanforbes4238
    @seanforbes4238 5 років тому

    Was there not a screw behind the interior door handle?

  • @Jordanmilo
    @Jordanmilo 6 років тому

    I have a 2013 Fiat 500 and for a couple of weeks the passenger window was making a popping sound when I lowered it. Now it's slipping. Am I dealing with a bad regulator or something else? Thanks for the vid and for your answer.

    • @gsgarage2462
      @gsgarage2462  6 років тому

      Sounds like a regulator. The problem is usually that the plastic clip piece attached to the window no longer stays on the track properly. I replaced with a Dorman unit since it was cheaper and I didn't have much faith that a Mopar unit was any better if it had already failed on a 6 year old car. Good luck with your repair.

    • @Jordanmilo
      @Jordanmilo 6 років тому

      Thanks for your reply. Next time it breaks (and it is a Fiat, so I'm sure there will be a next time) I'll fix it myself following your video, but I have an 8/80,000 extended warranty so I'm going to bring it to the dealer this afternoon. Thanks again!

    • @donnatolley2100
      @donnatolley2100 5 років тому

      2013 Fiat 500 sport want to replace driver's door entire door.

    • @gsgarage2462
      @gsgarage2462  5 років тому

      Looks to be just 2 hinge bolts, stopper allen bolt, and electrical connection that needs to be removed. Good luck