Have we been using accelerator wrong?

Have we been using accelerator wrong this whole time? What do you think of this new way to add a CA finish? I think everyone should give this way a try at least once! Thanks for watching and good luck!
JOIN OUR FACEBOOK GROUP!
/ 536332561230990
Check out our Custom rings!
DreamWoodShop.com
Check out our ring making tools-
shopdreamwood....
Our supplies-we are always adding new things!
shopdreamwood....
Some of what we use!
Paid Amazon Affiliate Links
Heater Water Kettle - amzn.to/3HOOccU
Veneer - amzn.to/309gwXq
Boring Head - amzn.to/3kjyvS6
3M Sandpaper - amzn.to/3mVflDC
Buck Tool Sander - amzn.to/305EenM
Rikon Bandsaw - amzn.to/3bPcjdY
Jet 1221 - amzn.to/3bSitd9
New Buffer - amzn.to/3bVPm8Z
Mitutoyo Callipers - amzn.to/3D9Dw6U
Cotton Polishing Wheels - amzn.to/3juosJe
Dremel polshing wheels - amzn.to/3JDgasN
3 piece Carbide tools - amzn.to/3J9yREj
Diamond Polishing set - amzn.to/3JxEoVw
for tungsten and ceramic

[@chelsea78344]

Holy CRAP I make pens and I am TOTALLY going to try this! I hope I never look back!! Also question - what rpm are you doing when you are applying the activator/CA?

[@susieholmes3037]

Good find! I shall try this out!

[@DreamwoodRings]

You should! It would work great with the rings you make.

[@jakubchecka8926]

i will try tomorrow!:D actually finishing is the worst part. I still get lots of white spots on the glue. Maybe there is too much dust in my workshop. Anyway, do you sometimes find a white dot under 5 layers of ca?:D takes lot's of time to repair;// any tips?:)

[@DreamwoodRings]

Hey it is possible dust around you is getting into the finish or perhaps your CA has air bubbles when it's coming out of the bottle, Check both if you find one bubble in the ring I sometimes take a Razer blade and cut that piece of the finish out, dab the area with acetone, and reapply the finish. It might take a minute or so to get used to it but at least you wouldn't have to refinish the whole piece